Step 2
Positioning,
Leveling, and
Securing the
Insert
Step 3
The Gas Control
Systems
1.Place the insert into position.
2.Level the insert from side to side and from front to back.
•If necessary use the legs included in the manual bag. Screw the legs into the nuts installed in the bottom rear of the insert. Turn legs in until insert is level.
WARNING
THIS UNIT IS NOT FOR USE WITH
SOLID FUEL.
The gas control systems used with this model is Standing Pilot Ignition.
Standing Pilot Ignition System
This system includes millivolt control valve, standing pilot, thermopile/thermocouple flame sensor, and piezo ignitor.
WARNING
STANDING PILOT
3/8" (10 mm)
Figure 6. Gas Controls Systems
10