Heat & Glo LifeStyle AT-GRAND manual Glass Assembly

Page 18

15

1.Lift the top trim door up and out of the unit.

2.Pull out and rotate the glass release eye bolts at the top and bottom edges and remove the glass door from the unit.

1.Place the ember material onto the top of the burner.

•Remove the glass door from the unit.

•Cover the top of the burner with a single layer of ember material. Then sprinkle GE-93 on top of the burner.

•Save the remaining ember materials for use during fireplace servicing.

•Replace the glass door.

•Reset the four glass eye bolts, be sure they are securely latched.

•Replace the trim door.

GLASS DOOR

Figure 10. Glass Assembly

Figure 11. Placement of the Ember Material

Image 18

Contents Heat-N-Glo Fireplace Safety and Warning Information Table of Contents Safety and Warning InformationApprovals and Codes CodesGetting Started Venting and Installation Diagram of the AT-GRAND Vent System Approvals Installing the Insert Step Vent SystemVent System Installation Precautions Horizontal VentingConnecting the Vent Pipe Flex pipes to the starting collars on the unit withMinimum Height from Roof to Lowest Discharge Opening Page Inlet AIR Standing Pilot Ignition System Gas Controls SystemsStep Gas Supply Line Gas Supply LineStep Gas Pressure Requirements Wiring Fireplace Pressure Natural Gas PropaneAppliance Requirements Optional Accessories Remote Wall SwitchSave the log instructions with this manual Step Installing Logs Ember MaterialPositioning the Logs Placing the Ember MaterialGlass Assembly Step Installing Trim Surrounds Mantel Double-check for faulty components Step Before Lighting Appliance After InstallationReview safety warnings and cautions Double-check for gas leaksAppliance Maintenance Maintaining and Servicing Your ApplianceBurner Flame Patterns Replacement Parts Accessories Standing Pilot OnlyStanding Pilot R T PA R T PAR T N U M B E R S C R IP T IO N