Heat & Glo LifeStyle manual Diagram of the AT-GRAND

Page 7

When planning a fireplace insert installation, it’s necessary to determine:

•The vent system configuration to be used.

•Gas supply piping.

•Whether optional accessories—devices such as a wall switch, or remote control—are desired.

24

13 1/2

TOP VIEW

33

SURROUND

ON/OFF

SWITCH

LOW

VOLTAGE

WIRES

MINIMUM FIREPLACE SIZE

FRONT WIDTH: 33” (839mm)

REAR WIDTH : 24” (610mm)

DEPTH	: 131/2” (343mm)
* HEIGHT	: 24” (610mm)

*NOTE: If exhaust collar on insert and fireplace damper do not line up, add 4 inches (102mm) to minimum fireplace height for bends in vent pipe.

Figure 1. Diagram of the AT-GRAND

4

Image 7

Contents Heat-N-Glo Fireplace Safety and Warning Information Safety and Warning Information Table of ContentsCodes Approvals and CodesGetting Started Venting and Installation Diagram of the AT-GRAND Horizontal Venting Installing the Insert Step Vent SystemVent System Installation Precautions Vent System ApprovalsFlex pipes to the starting collars on the unit with Connecting the Vent PipeMinimum Height from Roof to Lowest Discharge Opening Page Inlet AIR Gas Controls Systems Standing Pilot Ignition SystemGas Supply Line Step Gas Supply LinePressure Natural Gas Propane Step Gas Pressure Requirements Wiring FireplaceAppliance Requirements Remote Wall Switch Optional AccessoriesPlacing the Ember Material Step Installing Logs Ember MaterialPositioning the Logs Save the log instructions with this manualGlass Assembly Step Installing Trim Surrounds Mantel Double-check for gas leaks Step Before Lighting Appliance After InstallationReview safety warnings and cautions Double-check for faulty componentsMaintaining and Servicing Your Appliance Appliance MaintenanceBurner Flame Patterns Standing Pilot Only Replacement Parts AccessoriesStanding Pilot R T PA R T PAR T N U M B E R S C R IP T IO N