Heat & Glo LifeStyle AT-GRAND manual Getting Started

Page 5

Introducing the

Heat-N-Glo

Gas Appliances

Pre-installation Preparation

Heat-N-Glo direct vent gas appliances are designed to operate with all combustion air siphoned from outside of the building and all exhaust gases expelled to the outside.

The information contained in this Installers Guide, unless noted otherwise, applies to all models and gas control systems.

Gas appliance diagrams, including the dimensions, are shown in this section.

This gas insert and its components are tested and safe when installed in accordance with this Installers Guide. Report to your dealer any parts damaged in shipment, particularly the condition of the glass. Do not install any unit with damaged, incomplete, or substitute parts.

The vent system components and trim surrounds are shipped in separate packages. The gas logs are packaged separately and must be field installed. Read all of the instructions before starting the installation. Follow these instructions carefully during the installation to ensure maximum safety and benefit. Failure to follow these instructions will void the owner’s warranty and may present a fire hazard.

The Heat-N-Glo Fireplace Products, Inc. Warranty will be voided by, and Heat-N-Glo Fireplace Products, Inc. disclaims any responsibility for, the following actions:

•Installation of any damaged fireplace or vent system component.

•Modification of the fireplace or direct vent system.

•Installation other than as instructed by Heat-N-Glo Fireplace Products, Inc.

•Improper positioning of the gas logs or the glass door.

•Installation and/or use of any component part not manufactured and approved by Heat-N-Glo Fire- place Products, Inc., not withstanding any indepen- dent testing laboratory or other party approval of such component part or accessory.

ANY SUCH ACTION MAY POSSIBLY CAUSE A FIRE HAZARD.

2

Getting

Started

2

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Heat-N-Glo Fireplace Safety and Warning Information Safety and Warning Information Table of ContentsCodes Approvals and CodesGetting Started Venting and Installation Diagram of the AT-GRAND Vent System Installation Precautions Installing the Insert Step Vent SystemVent System Approvals Horizontal VentingFlex pipes to the starting collars on the unit with Connecting the Vent PipeMinimum Height from Roof to Lowest Discharge Opening Page Inlet AIR Gas Controls Systems Standing Pilot Ignition SystemGas Supply Line Step Gas Supply LineAppliance Requirements Step Gas Pressure Requirements Wiring FireplacePressure Natural Gas Propane Remote Wall Switch Optional AccessoriesPositioning the Logs Step Installing Logs Ember MaterialSave the log instructions with this manual Placing the Ember MaterialGlass Assembly Step Installing Trim Surrounds Mantel Review safety warnings and cautions Step Before Lighting Appliance After InstallationDouble-check for faulty components Double-check for gas leaksMaintaining and Servicing Your Appliance Appliance MaintenanceBurner Flame Patterns Standing Pilot Only Replacement Parts AccessoriesStanding Pilot R T PA R T PAR T N U M B E R S C R IP T IO N
Top Page Image Contents