Heat & Glo LifeStyle AT-GRAND manual Step Installing Logs Ember Material, Positioning the Logs

	FAN WIRING DIAGRAM
	VARIABLE SPEED CONTROL
BLK	BLK

		JUNCTION BOX
BLK	BLK
		BLK
BLK		BLK
		WHT
		BLK
		GROUND
TEMPERATURE
SENSOR SWITCH
		GRN
		BLK	WHT
		110-120 VAC

NOTE: IF ANY OF THE ORIGINAL WIRE AS SUPPLIED WITH THE APPLIANCE MUST BE REPLACED, IT MUST BE REPLACED WITH TYPE 105 DEGREE C RATED WIRE.

BLOWER RECEPTACLE

BLK

WHT

BLOWER

JUNCTION	TEMPERATURE
BOX	SENSOR SWITCH

FAN

SPEED CONTROL (RHEOSTAT)

Figure 9. Fan Wiring Diagram

Step 7

Installing Logs

and Ember

Material

Positioning the Logs

If the gas logs have been factory installed they should not need to be positioned.

If the logs have been packaged separately, refer to the installation instructions that accompany the logs.

Save the log instructions with this manual.

If sooting occurs, the logs might need to be repositioned slightly to avoid excessive flame impingement.

Placing the Ember Material

Two separate bags of ember material are shipped with this gas appliance:

•The bag labeled Golden Ember (GE-93) is flame colorant material.

•The bag labeled Glowing Ember (050-721) is standard glowing ember material.

To place the ember material:

•Remove the trim door by lifting up and removing from the unit.

•Pull out and rotate the four glass release eye bolts at the top and bottom of the glass.

14