Heat & Glo LifeStyle owner manual System Wiring, 6100PLUS Requirements

C. System Wiring

6100PLUS Requirements

•This gas appliance requires a 110VAC supply to the gas appliance junction box for operation. A wiring diagram is shown in Figure 8.1.

•The 6100PLUS is equipped with an intermittent pilot control valve which operates on a 3 volt system. See ignition wiring diagram, Figure 8.1.

•The 6100PLUS is supplied with a 3 volt AC transformer, which requires the installation of the supplied junction box. It is highly recommended that the junction box be installed at this time to avoid future reconstruction.

Note: Wire terminal latch can become damaged if excessive force is used when releasing wire. Please use caution in pressing retainer.

Figure 8.1 Intermittent Pilot Ignition Wiring Diagram

Note: The 6100PLUS must be electrically wired and grounded in accordance with local codes or, in the absence of local codes, with National Electric Code ANSI/NFPA 70-latest edition or the Canadian Electric Code,

CSA C22.1.

Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05 15