Heat & Glo LifeStyle 6100PLUS Grate and Log Assembly, Place the Grate, Place the Right Front Log

Page 23

D. Grate and Log Assembly

Place the Grate

•Place the grate around the burner. Push back the grate until the left middle piece of the grate comes in contact with the burner assembly. See Figure 10.8.

Place the Right Front Log

•Place the right front log along the right side of the grate so the notch in the log rests on the right side of the grate and the left side rests on the burner. See Figure 10.11.

Figure 10.8 Place Grate

Figure 10.11 Right Front Log

Place the Back Log	Place the Top Log
• Place the back log along the back of the burner so the	• Place the top log so the right side of the log ﬁ ts into the
notches in the log rest on the grate as shown The top	notch on the right front log and the left side rests on the
back corners of the log will touch the refractory. See	top of the back log. See Figure 10.12.
Figure 10.9.

Figure 10.9 Back Log

Figure 10.12 Top Log

Place the Left Front Log

•Place the left front log in front of the back log so the notches rest on the grate. See Figure 10.10.

Figure 10.10 Left Front Log

Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05

23

Image 23

Contents What to do if you smell gas Models 6100PLUS Fresh Air FireplaceListing Label Information/Location Homeowner Reference InformationTable of Contents Non-Combustible Materials High Altitude InstallationsListing and Code Approvals Appliance CertiﬁcationInspect the Appliance and Components Design and Installation ConsiderationsGetting Started Tools and Supplies NeededFire Risk Framing and ClearancesSelect Appliance Location Fire Risk Odor Risk Construct the Appliance ChaseMantel Projections ClearancesFire Risk Explosion Risk Termination LocationsVent Termination Minimum Clearances Fire Risk Fumes Risk Vent Information and DiagramsSecuring and Leveling the Appliance Appliance PreparationGas Leak Risk Gas InformationFuel Conversion Gas Connection Gas PressureFire Risk Explosion Risk Asphyxiation Risk Shock Risk Explosion Risk Recommendation for WireConnecting to the Appliance Electrical Information6100PLUS Requirements System WiringBetween R2 HRV200PLUS Control WiringAppliance Circuit Board Wiring Electric Embers On/Off Wall SwitchOptional Accessories Requirements Flame On/OffJunction Box Detail Junction Box InstallationFacing Material FinishingRemove the Shipping Materials Appliance SetupClean the Appliance Lava Rock, Rockwool, Silica Rock PlacementPlacing the Silica Rock Techno Sil Placing the Rock WoolPlace the Top Log Grate and Log AssemblyPlace the Grate Place the Right Front LogFire Risk Burn Risk Appliance ModeOperating Instructions Sequence of OperationHRV200PLUS Defrost Mode Lighting the Appliance After the Appliance is Lit Initial Break-in ProcedureFire Risk High Temperatures Troubleshooting Guide TroubleshootingMaintaining and Servicing the Appliance Annual MaintenanceEmber Bed Bulb Replacement Cleaning the Burner and Control CompartmentThis page intentionally left blank Reference Materials Appliance Dimension Diagram6100PLUS Service Parts ListLog Set Refractory Assembly, Traditional6100PLUS 6100PLUS-LP Description of Part 6100PLUSSpvn Spwd Spwv Remote Control Wall SwitchOptional Components SpflArched Cabinet Doors Prism Series Optional Components 6100PLUS 6100PLUS-LP QtyArched Cabinet Doors Essence Series This page intentionally left blank Limited Lifetime Warranty Contact Information