1Listing and Code Approvals
A. Appliance Certification | B. BTU Specifications |
MODELS: 6100PLUS
LABORATORY: Underwriters Laboratories, Inc. (UL)
TYPE: Vented Gas Appliance
STANDARD: ANSI
CSA
| Max Input | Min Input |
|
Model | BTUH | BTUH | Orifice Size |
47,000 | 34,000 | .082 in./2.08 mm | |
47,000 | 34,000 | .136 in./3.45 mm |
C. High Altitude Installations
NOT INTENDED FOR USE AS A PRIMARY HEAT SOURCE. This appliance is tested and approved as either supplemental room heat or as a decorative appliance. It should not be factored as primary heat in residential heating calculations.
Note: This installation must conform with local codes. In the absence of local codes you must comply with the National
Fuel Gas Code, ANSI
WARNING
This is a
The 6100PLUS is power vented. High altitude gas appliance considerations are no longer of concern, as long as the gas appliance is properly installed with the HRV200PLUS prop- erly balanced (refer to HRV200PLUS manual).
Note: This appliance CANNOT be installed at an elevation above 6,200 ft (1,890 meters)
WARNING
Do NOT use this appliance if any part has been under water. Immediately call a qualifi ed service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
E. Non-Combustible Materials
Materials that are reported as passing ASTM E 136, Stan- dard Test Method for Behavior of Materials in a Vertical Tube Furnace at 750° C, shall be considered
F. Combustible Materials
Materials made of or surfaced with wood, compressed pa- per, plant fi bers, plastics, or other material that can ignite and burn, whether fl ame proofed or not, or whether plastered or unplastered shall be considered combustible materials.
4 | Hearth & Home Technologies • 6100PLUS • |