Desa VTGF33NR, VTGF33PR Operating Fireplace, Installing Battery Into Remote, Installing Screen

24

INSTALLATION

Installing Battery Into Remote Installing Screen

OPERATING FIREPLACE

For Your Safety Read Before Lighting

INSTALLATION

Continued

INSTALLING BATTERY INTO REMOTE

1.Locate slot at bottom of remote control (see Figure 53). Firmly insert tool such as a small screwdriver, butter knife, or dime into the slot and lift up to remove cover.

2.Insert supplied battery into remote control. Positive and nega- tive are marked inside remote control casing. Note: Remote will not function if battery is not installed correctly.

3.Slide tab on cover into remote housing and snap cover back into place.

IMPORTANT: Use only A23 12 volt battery in remote. DO NOT use AAA battery.

Tab

OPERATING FIREPLACE

FOR YOUR SAFETY READ

BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing prop- erty damage, personal injury or loss of life.

A.	This appliance has a pilot which lights automatically when
	using the supplied wall switch or remote control. If you
	have a power outage, the pilot may be lighted by hand with
	push-button piezo ignitor. When lighting the pilot, the fol-
	lowing warnings must be followed.
B.	BEFORE LIGHTING smell all around the appliance area

Slot

A23 12

Volt

Battery

Cover

for gas. Be sure to smell next to the floor because some gas
is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•	Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone in
	your building.
•	Immediately call your gas supplier from a neighbor’s
	phone. Follow the gas supplier’s instructions.
•	If you cannot reach your gas supplier, call the fire de-

Positive	Remote
	Control
Negative
Figure 53 - Installing Battery

INSTALLING SCREEN

Install fireplace screen by slipping notches of fireplace screen over screws on front of fireplace (see Figure 54).

Notches

Screws for

Mounting Screen

Figure 54 - Installing Fireplace Screen (EFP33PR Shown)

partment.

C. Electric Power Outage Only: Use only your hand to turn

the manual override handle on the gas control knob. Never

use tools. If the knob will not turn by hand, don’t try to

repair it, call a qualified service technician or gas supplier.

Force or attempted repair may result in a fire or explosion.

D. Do not use this appliance if any part has been under water.

Immediately call a qualified service technician to inspect

the appliance and to replace any part of the control system

and any gas control which has been under water.

For..com

108117