Desa INSTALLING LOGS CGEFP33PR/CGEFP33NR, Installing Hood, Installation, Continued

INSTALLATION

Assembling And Attaching Optional Brass Trim (Cont.)

Installing Hood

Installing Logs (CGEFP33PR/CGEFP33NR)

21

INSTALLATION

Continued

		Set Screws
Side Brass	Adjusting	Top Brass
Trim	Plate
		Trim

Slot

Shim

Slot

Mitered Edge

Figure 38 - Assembling Brass Trim

INSTALLING LOGS (CGEFP33PR/CGEFP33NR)

WARNING: Failure to position the parts in accor- dance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

CAUTION: Do not remove the warning and in- struction labels attached to the heater base assem- bly. These markings contain important warranty in- formation.

Trim

Hanging

Screws

Hanging Notches on Trim

Assembled

Brass Trim

Figure 39 - Attaching Brass Trim to Fireplace (EFP33PR Shown)

INSTALLING HOOD

Install hood to top of firebox as shown in Figure 40. Use 3 Phillips screws provided.

CAUTION: After installation and periodically there- after, check to ensure that no flame comes in contact with any log. With the heater set to HI, check to see if flames contact any log. If so, reposition logs accord- ing to the log installation instructions in this manual. Flames contacting logs will create soot.

Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

1.Locate pegs on the bottom of back log (#1). Slide these pegs into the holes in the grate base behind the burner (see Figure 41).

2.Place the base of the middle log (#2) in the U-shaped slots of the grate base in front of the back log. The cutout on the right of the middle log should fit over the burner (see Figure 42). Make sure the front of the middle log is resting on the tabs of the grate base and the cutout area is centered over the burner “U” bend.

3.Locate the recesses on the back of the front log (#3). Fit these recesses between the posts of the grate base (see Figure 43, page 22).

	Back	Middle
		Log	Cutout
	Log	(#2)
Hole in	(#1)
Grate		Tab
Base
		Burner

Figure 40 - Installing Hood to Firebox (EFP33PR Shown)

Burner	“U” Bend
	U-Shaped Slot
Figure 41 - Installing Back	Figure 42 - Installing Middle
Log (#1)	Log (#2)

For morevisit www..com

108117-01H