INSTALLING LOGS EFP33PR/EFP33NR, Installation, Continued

INSTALLATION

Installing Logs (CGEFP33PR/CGEFP33NR) (Cont.) Installing Logs (EFP33PR/EFP33NR)

INSTALLATION

Continued

4.Locate the notches in the bottom of the crossover log (#4). Place the crossover log on top of the middle log and front log. Make sure the notches of the crossover log lines up with rectangular knobs on top of the middle and front logs (see Figure 44).

Front Log (#3)

Recess

Crossover

Log (#4)

Post	Rectangular
Post	Knobs

middle log is resting on the tabs of the grate base and the cut- out area is centered over the burner “U” bend.

2.Locate pegs on the bottom of back log (#2). Slide these pegs into the holes in the grate base behind the burner (see Figure 46).

3.Locate the notches in the bottom of the front log (#3). Place the front log on the grate fingers. Make sure the notches of the front log line up with the grate fingers (see Figure 47).

4.Place crossover log (#4) onto the peg (right) on back log (#2) and into the recess of the middle log (#1) (see Figure 48).

Middle	Back Log (#2)
Log (#1)
"U"-	Peg
shaped	Peg
Cutout
in Base

Peg

Figure 43 - Installing Front	Figure 44 - Installing
Log (#3)	Crossover Log (#4)

INSTALLING LOGS (EFP33PR/EFP33NR)

WARNING: Failure to position the parts in accor- dance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

CAUTION: Do not remove the warning and in- struction labels attached to the heater base assem- bly. These markings contain important warranty information.

CAUTION: After installation and periodically there- after, check to ensure that no flame comes in contact with any log. With the heater set to HIGH, check to see if flames contact any log. If so, reposition logs ac- cording to the log installation instructions in this manual. Flames contacting logs will create soot.

Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

1.Place the base of the middle log (#1) in the U-shaped slots of the grate base. The cutout on the right of the middle log should fit over the burner (see Figure 45). Make sure the front of the