OWNER’S MANUAL
FIREPLACE INSTALLATION
Continued
INSTALLING LOGS, LAVA ROCK AND GLOWING EMBERS
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with fireplace.
1.Remove glass door. See Removing/Re- placing Glass Door, page 21.
2.Place log #1 (back log) on top of grate. Make sure the notches in the bottom of the log fit over the grate (see Figure 47).
3.Rest log #2 (large front log) on the pins on the front part of the grate (see Figure 48).
4.Place log #3 (left piece) onto the front left part of the grate. Make sure it is seated properly over the prong of the grate as shown in Figure 49.
5.Place log #4 (right piece) onto the front right part of the grate making sure the notches fit over the prong of the grate (see Figure 50).
6.Place lava rock along sides and front of inside of firebox bottom. It is not necessary to use all of the lava rock provided.
7.Pull ember material apart into pieces no larger than a dime. Place these pieces loosely and sparingly directly onto the exposed section of the front burner and along the space between the burner and grate prongs (see Figure 51).
NOTICE: Do not put lava rock on burner or under burner. Placing lava rock on burner could cause performance problems.
This will create the glowing ember ap- pearance as the flame touches the em- ber material. Do not block air slots by using too much ember material in one area. It is not necessary to use all of the ember material provided.
8.Replace the glass door. See Removing/ Replacing Glass Door, page 21.
WARNING: The glass door must be securely in place before running this fireplace. Do not run this fireplace if glass is missing or broken.
1
Figure 47 - Installing Log No. 1
2
Figure 48 - Installing Log No. 2
3
Figure 49 - Installing Log No. 3
4
Figure 50 - Installing Log No. 4
Ember Material
Figure 51 - Placing Ember Material on Burner
105982 | 23 |