Desa DVFE34 Operating Fireplace, For Your Safety Read Before Lighting, Lighting Instructions

Page 24

DIRECT-VENT FIREPLACE

OPERATING

FIREPLACE

FOR YOUR SAFETY

READ BEFORE

LIGHTING

WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result caus- ing property damage, personal injury or loss of life.

A.This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance.

•Do not touch any electric switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don't try to repair it, call a qualified service technician. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been un- der water.

LIGHTING

INSTRUCTIONS

1.STOP! Read the safety information in column one.

2.Open lower louver panel.

3.Turn wall switch to “OFF”.

4.Turn off all electric power to the fireplace.

5.Turn the equipment shutoff valve

clockwise to the OFF position (see Figure 50). Do not force.

6.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety in- formation in column one. If you don't smell gas, go to the next step.

7.Turn equipment shutoff valve counter-

clockwise to the ON position.

8.Turn on all electrical power to the appliance.

9.Turn the wall switch to the ON position.

10.Visually locate the pilot. The ignitor should begin to spark and the main burner should ignite once flame ap- pears at pilot.

•If lighting the appliance for the first time each season, it may take several attempts before the supply gas can reach the pilot and main burners.

•If the appliance will not stay lit af- ter several attempts, follow the in- structions To Turn Off Gas To Ap- pliance, column 3, and call your service technician or gas supplier.

11.Close lower louver panel.

Equipment Shutoff Valve

Control Valve

Figure 50 - Turning the Equipment Shutoff Valve to the OFF position

TO TURN OFF GAS

TO APPLIANCE

1.Turn off the wall switch.

2.Turn off all electric power to the ap- pliance if service is to be performed.

3.Open control access panel.

4.Turn equipment shutoff valve clock- wise Clockwise to “OFF”. Do not force.

5.Close control access panel.

OPTIONAL REMOTE

OPERATION

Note: The WRC receiver and hand-held remote control kit mustbepurchasedsepa- rately (see Accessories, page 34). Follow installation instructions on page 21.

1.Turn equipment shutoff valve to ON position. You can now turn the burner on and off with the hand-held remote control unit.

IMPORTANT: Be sure to press the ON/OFF buttons on the hand-held remote control unit for up to 3 sec- onds to assure proper operation.

2.Press the ON/OFF button to turn the burner on and off.

Pilot

AssemblyIgnitor/Sensor

Figure 51 - Pilot

For more information, visit www.desatech.com

24

107205

Page 23 Page 25
Image 24
Page 23 Page 25
Contents For Your Safety For Your Safety What to do if YOU Smell GASDVFE34 Natural Electronic Ignition Safety Information DIRECT-VENT FireplaceProduct Identification Local CodesGlossary Terms OperationPRE-INSTALLATION Preparation Location and Space RequirementsClearances Framing and FinishingPRE-INSTALLATION General Venting Preparation Location of VentTermination General Venting Venting Installation Installation PrecautionsInstallation Planning Installing Vent System in a ChaseInstallation for Horizontal Termination Snorkel TerminationFor vinyl siding use vinyl siding stand Rigid Vent Pipe Horizontal Termination Configurations Rigid Vent Pipe Horizontal VentingVenting with Two 90 Elbows Installation for Vertical Termination Flat Ceiling InstallationCathedral Ceiling Installation Vertical Termination Configurations Venting with Two 90 Elbow sVertical Venting High Altitude Installation Parts Lists for Venting Kits and ComponentsFMI Rigid Venting Fireplace Installation Installing Optional Blower AccessoryInstalling GA3700/DA3610TA Blowers Check GAS TypeIf your fireplace system is installed Installing GAS Piping to Fireplace Location Installation Items NeededConnecting Fireplace to GAS Supply Pressure Testing Gas Supply Piping SystemChecking GAS Connections Pressure Testing Fireplace Gas Connections Close equipment shutoff valve see Fig- ureInstalling Optional Wall Mount Switch GWMS2 REMOVING/REPLACING Glass DoorInstalling Optional Brick Liner D8037A Attaching Magnetic Decorative Brass StripsInstalling LOGS, Lava Rock and Glowing Embers Installing Log NoFor Your Safety Read Before Lighting Operating FireplaceLighting Instructions To Turn OFF GAS To ApplianceOperating Optional Blower Accessory Operating Optional GWMS2 Wall Mounted SwitchPilot Assembly Inspecting BurnersCleaning and Maintenance Glass DoorPilot and Burners LogsTroubleshooting Observed Problem Possible Cause RemedyOrifice Gas leak. See Warning statement Replacement Parts Service HintsTechnical Service Wiring DiagramsSpecifications DVFE34Illustrated Parts Breakdown DVFE34Parts List KEY Part Number Description QTYAccessories 107205 Warranty Information

DVFE34 specifications

Desa DVFE34 is a cutting-edge development designed to meet the demanding needs of modern urban living. This residential complex stands out due to its innovative architecture, sustainable technologies, and its commitment to enhancing the quality of life for its residents.

One of the main features of Desa DVFE34 is its environmentally friendly design. The complex has been constructed with sustainable materials that minimize its carbon footprint. Solar panels are integrated into the building's structure, providing renewable energy for common areas and reducing reliance on non-renewable power sources. The implementation of rainwater harvesting systems ensures efficient use of water resources, promoting sustainability within the community.

In terms of technology, Desa DVFE34 is equipped with smart home capabilities. Residents can control various aspects of their homes—from lighting to heating—through a centralized app on their smartphones. This not only adds convenience but also allows for energy savings and enhances security. The incorporation of security systems with smart alarms and surveillance cameras ensures a safe living environment.

The layout of the building is thoughtfully designed to maximize space and comfort. Spacious apartments come with modern finishes, high ceilings, and large windows that allow plenty of natural light to flow in. Common areas include beautifully landscaped gardens, recreational spaces, and fitness facilities that encourage a healthy lifestyle. Additionally, designated areas for social gatherings foster a sense of community among residents.

Accessibility is a key characteristic of Desa DVFE34. Located in a prime urban area, residents have easy access to public transport, shopping centers, and essential services. This not only facilitates daily commutes but also enhances the overall living experience by placing residents in the heart of the city’s amenities.

In summary, Desa DVFE34 represents a harmonious blend of modern living and sustainable practices. Its innovative features, from smart technologies to eco-friendly designs, set a new standard for urban residential developments. By prioritizing both comfort and sustainability, Desa DVFE34 is an exemplary model of what future living spaces can and should be.
Top Page Image Contents