Desa K36EN, K36EP Pre-Installation Preparation, Continued, Clearances, Framing And Finishing

PRE-INSTALLATION PREPARATION

Clearances

Framing and Finishing

5

PRE-INSTALLATION

PREPARATION

Continued

CLEARANCES

Minimum clearances to combustibles for the fireplace are as follows:

Back, and sides	0"/mm
Perpendicular walls	6" (152mm)
Floor	0"/mm
Ceiling to louver opening	42" (1067mm)
Front	36" (914mm)
Top	0"/mm
Vent	(See venting instructions for
	specific venting clearances.)

Combustible material with a maximum thickness of 5/8" may be

15"

35 3/4"

10 3/8" 49 5/8"

133/4"

41"

411/4" Nailing Tabs

681/2"

flush with the top front of fireplace .

NOTICE: This fireplace is intended for use as supple- mental heat. Use this fireplace along with your pri- mary heating system. Do not install this fireplace as your primary heat source. If you have a central heat- ing system, you may run system’s circulating blower while using fireplace. This will help circulate the heat throughout the house. In the event of a power outage, you can use this fireplace as a heat source.

FRAMING AND FINISHING

Figure 4 shows typical framing of this fireplace. Figure 5 shows framing for corner installation. All minimum clearances must be met.

For available accessories for this fireplace, see Accessories on page 34. If you are using a separate combustible mantel piece, refer to Figure 6 for proper installation height. You can install noncombustible mantels at any height above the fireplace. Note: Noncombustible mantels may discolor!

361/8"

411/4"

231/2"

Figure 5 - Framing Clearances for Corner Installation

										1
										2
										3
		A									Wall
										4
			B							5
					C					6
						D
							E			7
								F
									G
						Top of Louver Opening
Ref.	Mantel Depth		Ref.			Mantel from Top
						of Louver Opening
1	14" (356mm)			A		16" (406mm)
2	12" (305mm)			B		14" (356mm)
3	10" (254mm)			C		12" (305mm)
4	8" (203mm)			D		10" (254mm)
5	6" (152mm)			E		8" (203mm)
6	4" (101mm)			F		6" (152mm)
7	2" (51mm)			G		4" (101mm)

Figure 6 - Clearances for Combustible Mantels

Figure 4 - Framing Clearances for Installation Against an

Exterior Wall

For morevisit www..com

111924-01A