8
LOG PLACEMENT
Positioning the logs improperly will cause flame im- pingement and carboning.
PHAZERTM logs and glowing embers, exclusive to Continental Fireplaces, glow when exposed to direct flame and provide a unique and realistic glowing effect that is different in every installation. Take the time to carefully position the glowing embers for a maximum glowing effect. Use only certified PHAZERTM logs available from your Continental / Wolf Steel Ltd. dealer.
1.Place the rear log (#1) onto the two log supports and against the air intake pipe.
FIGURE 12
#1
DOOR INSTALLATION
Place the door into the two lower door brackets, and se- cure at the top of the unit with two
FIGURE 16
LOWER DOOR BRACKET
2.Position logs #2 and #3 against the grate posts and line up the studs located on the burner with the holes on the bottom of the logs. Keep slightly back of the front row of ports.
FIGURE 13
#2
#3
3.Fit the centre log (#4) into place behind log #3 and into the pocket provided on the back log.
FIGURE 14
#4
FIGURE 15
GLOWING EMBERS
MANTLE CLEARANCE
This can vary according to the mantle depth. Use the graph to help evaluate the clearance needed.
FIGURE 17
M H |
A E |
N I |
T G |
L H |
E T |
MANTLE WIDTH
LOGO PLACEMENT
Remove the backing of the logo supplied and place on the glass viewing door, as indicated.
4. Tear the glowing embers into pieces and place along |
|
|
|
|
|
the front row of ports covering all of the burner area in front |
|
|
|
|
|
of the logs. Care should be taken to shred the embers into |
|
|
|
|
|
thin, small irregular pieces as only the exposed edges of |
|
|
|
|
|
the fibre hairs will glow. The ember material will only glow | ½” |
|
| ||
when exposed to direct flame; however, care should be |
|
| |||
| |||||
taken to not block the burner ports. Blocked burner ports |
|
|
|
|
|
|
|
|
|
| |
can cause an incorrect flame pattern, carbon deposits and |
|
|
|
|
|
delayed ignition. |
|
|
|
|
|
Log colours may vary. During the initial use of the fireplace, |
|
|
|
|
|
the colours will become more uniform as colour pigments | FIGURE 18 | ||||
burn in during the heat activated curing process. | |||||
LOGO
½”