LIGHTING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING 
WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EX- PLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY, OR LOSS OF LIFE.
A.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electrical switch.
•Do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you can not reach your gas supplier, call the fire de- partment.
B.Use on the wall switch or remote control switch to turn the gas control on/off. Any attempted repairs or adjustments should be performed by a qualified service technician. Ap- plying force or attempted repair may result in a fire or ex- plosion.
C.Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
LIGHTING INSTRUCTIONS
1.STOP! Read the safety information above on this label.
2.Set the thermostat, if used, to the lowest setting.
3.Turn off all electric power to the appliance. Turn off elec- trical control switches to “O.”
4.This appliance is equipped with an ignition device that au- tomatically lights the burner. Do not try to light the burner by hand.
5.Remove the front access panel below the glass door by pulling both sides forward simultaneously.
6.Turn gas line valve to “ON.”
7.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Fol-
low “A” in the safety information above. If you do not smell gas, go to the next step.
8.Replace the front access panel, press both sides of the panel until both lock position.
9.Turn on electric power to the appliance. Turn on electric control switches to “I.”
10.Set thermostat to desired setting (if available).
11.If the appliance will not operate, follow the instructions “TO TURN OFF GAS TO APPLIANCE,” and call your service technician or gas supplier.
OFF
ON
TO TURN OFF GAS TO APPLIANCE 
1. | STOP! Read the safety information above. | 4. | Remove front access panel. |
2. | Set the thermostat, if used, to the lowest setting. | 5. | Turn gas line valve to “OFF.” |
3. | Turn off electric power to the appliance. | 6. | Replace front access panel. |
Page 37 |