Empire Comfort Systems PV-28SV50-B2H(N,P)-1, PV-28SV50-B(N,P)-1 Rough Framing Dimensions

Page 16

ROUGH FRAMING DIMENSIONS

A - 13

/34” MIN. CO-LINEAR

8

1/2” WHEN USING DIRECT VENTING

PVVK-24H/PVVK-48H

NOTE: DIMENSIONS FOR USE WITH SHORT TOP

PV4H. THIS IS RECOMMENDED FOR UNIT

SERVICEABILITY.

B - 25 1/8”

C - 28”

NOTE: IF TRIM AROUND HEATER IS NECESSARY,

THE SURROUND KIT PVE-1 MUST BE USED,

AND SUBTRACT 1” FROM (A) DIMENSION.

Figure 12

INSERT INTO MASONRY FIREPLACE

A

-

12

3/4” MIN. SHORT TOP PV4H

 

 

17

13/16” MIN. SLIM TOP PV2H

 

 

USING PVE-1 SURROUND KIT

B

-

25

1/8” MIN. DIRECT VENT

 

 

26

1/2” MIN. SINGLE FLUE

 

 

29” MAX

C

-

28” MIN. NO SURROUND

 

 

33” MIN. WITH PVE-1 SURROUND

 

 

35” MAX. WITH PVE-1 SURROUND

Figure 13

Page 16

24820-1-0409

Image 16
Contents Empire Table of Contents Important Safety Information This is a Heating ApplianceSafety Information for Users of LP-GAS LP-GAS Warning OdorRequirements for Massachusetts Vent Directly BELOW. Keep Clear of ALL ObstructionsInstalling a New Main Gas Cock Pressure Testing of the Gas Supply SystemGAS Supply Recommended Gas Pipe DiameterIntroduction Specifications Installation Instructions General Safety InformationHeater Installation for Direct Vent Installation on Rugs and TileClearances for Direct Vent Locating Wall OpeningHeater Installation for Single Flue Clearances for Single FlueHeater with Pedestal and Single Flue Adaptor Specifications Heater without pedestalFireplace Insert with Mantel Surround with Slim Top Panel Fireplace Insert with Mantel Surround with Short Top Panel Clearance to Combustibles Freestanding UnitsRough Framing Dimensions Insert Into Masonry FireplaceWall Clearances LOG SET Installation Instructions Log Installation All LogsVent Examples for Single Flue Single Flue Venting with Shroud Installed Venting for Existing Fireplace InstallationSingle Flue Vertical Vent Run Shroud Kit Model# Pvsh Roof Determining Minimum Vent Height AboveSingle Flue Vertical Vent Run With 45 degree elbows Available from Empire Comfort Systems, Inc PVVK-CFA Flex Vent KITDetermining Minimum Vent Height Above the Roof PVVK-SH Horizontal Vent Adaptor KIT Horizontal Examples for Colinear Direct Vent Vertical Examples for Colinear Direct Vent Colinear Direct Vent Pitched Roof Installation Pvca Horizontal Colinear Direct Vent Adaptor Colinear adaptorPvvtc Termination CAP Vent KIT Termination CapFlat Roof or Chimney Application Pvct Colinear Transition Vent KITHorizontal Application Horizontal Venting Direct Vent Installation InstructionsDirect Vent System Building Exterior View Minimum Exterior Grade Dimension Unit Without Pedestal Minimum Exterior Grade Dimension Unit With PedestalPVVK-24H and PVVK-48H Vent KIT StepPVVK-24H and PVVK-48H Vent KIT GAS Connection Installation Instructions GAS Connection Line SupplyOperating Instructions Checklist Lighting Instructions For Your Safety Read Before Lighting FAN Operation GAS Conversion Instructions Conversion Instructions from LP Propane GAS to Natural GASConversion Instructions from Natural GAS to LP Propane GAS Automatic Humidifier Operation Installation Instruction for TMV2 Two Stage Thermostat Model Optional ControllersEconomy Display Mode Wiring Wiring DiagramMaintenance Over Temperature Cut OutGeneral Information Paint Curing First FiringFront door removal drawing Glass Cleaning Glass Assembly ReplacementMain Burner Drawing Cleaning Main Burner General Glass InformationResetting the Heater Unit Operating FaultsLOG Placement Main Convection FAN Surround Installation InstructionsHeat Exchanger Pedestal Installation Instructions Optional Pedestal Assembly InstallationParts List Index Part Number DescriptionGAS Line Rear Parts View Parts View Warranty Terms Purchase Date Dealer Name/PhoneHOW to Order Repair Parts Parts Not Under WarrantyWarranty Parts Master Parts Distributor ListComfort Systems