Empire Comfort Systems PV-28SV55-(C,G)2H(N,P)-1, PV-28SV50-B2H(N,P)-1 PVVK-CFA Flex Vent KIT

Page 22

PVVK-CFA FLEX VENT KIT

Available from Empire Comfort Systems, Inc.

The flex vent kit is a flexible vent hose that is 42” in length. The flex vent kit will be used when installing a Mantis into an existing fireplace. The flex vent kit can be cut down, but can only be cut from one end.

Cement PVC Joints

Cut End

Cement PVC Joints

Once length is determined, install two (2) 10 x 1/2” screws into the adaptor assembly to secure the adaptor assembly to the flex hose. Using PVC cement, cement all PVC joints of the flex vent kit to the remaining PVC vent run.

Determining Minimum Vent Height Above the Roof

WARNING: Major U.S. building codes specify minimum chimney and/or vent height above the rooftop. These minimum heights are necessary in the interest of safety.

VENT CAP (SUPPLIED

WITH VENT KIT)

GALV. SHEET FLASHING TO SEAL CHIMNEY (SUPPLIED BY INSTALLER)

PVC PIPE SWV (SUPPLIED BY INSTALLER)

(2)- 45 DEG. PVC BENDS (SUPPLIED BY INSTALLER

IF NECCESSARY)

 

ROOF PITCH

H (Min.)

 

Flat to 6/12

12” (305 mm)

 

6/12 to 7/12

15” (381 mm)

 

Over 7/12 to 8/12

18” (457 mm)

CUT END

Over 8/12 to 16/12

24” (610 mm)

 

Over 16/12 to 21/12

36” (914 mm)

FLEXIBLE

FLUE KIT

FLEXIBLE GAS

LINE

Venting for Existing Fireplace Installation

Page 22

24820-1-0409

Image 22
Contents Empire Table of Contents Important Safety Information This is a Heating ApplianceSafety Information for Users of LP-GAS LP-GAS Warning OdorRequirements for Massachusetts Vent Directly BELOW. Keep Clear of ALL ObstructionsGAS Supply Installing a New Main Gas CockPressure Testing of the Gas Supply System Recommended Gas Pipe DiameterIntroduction Specifications Installation Instructions General Safety InformationClearances for Direct Vent Heater Installation for Direct VentInstallation on Rugs and Tile Locating Wall OpeningHeater Installation for Single Flue Clearances for Single FlueHeater with Pedestal and Single Flue Adaptor Specifications Heater without pedestalFireplace Insert with Mantel Surround with Slim Top Panel Fireplace Insert with Mantel Surround with Short Top Panel Clearance to Combustibles Freestanding UnitsRough Framing Dimensions Insert Into Masonry FireplaceWall Clearances LOG SET Installation Instructions Log Installation All LogsVent Examples for Single Flue Single Flue Venting with Shroud Installed Venting for Existing Fireplace InstallationSingle Flue Vertical Vent Run Shroud Kit Model# Pvsh Roof Determining Minimum Vent Height AboveSingle Flue Vertical Vent Run With 45 degree elbows Available from Empire Comfort Systems, Inc PVVK-CFA Flex Vent KITDetermining Minimum Vent Height Above the Roof PVVK-SH Horizontal Vent Adaptor KIT Horizontal Examples for Colinear Direct Vent Vertical Examples for Colinear Direct Vent Colinear Direct Vent Pitched Roof Installation Pvca Horizontal Colinear Direct Vent Adaptor Colinear adaptorPvvtc Termination CAP Vent KIT Termination CapFlat Roof or Chimney Application Pvct Colinear Transition Vent KITHorizontal Application Horizontal Venting Direct Vent Installation InstructionsDirect Vent System Building Exterior View Minimum Exterior Grade Dimension Unit Without Pedestal Minimum Exterior Grade Dimension Unit With PedestalPVVK-24H and PVVK-48H Vent KIT StepPVVK-24H and PVVK-48H Vent KIT GAS Connection Installation Instructions GAS Connection Line SupplyOperating Instructions Checklist Lighting Instructions For Your Safety Read Before Lighting FAN Operation GAS Conversion Instructions Conversion Instructions from LP Propane GAS to Natural GASConversion Instructions from Natural GAS to LP Propane GAS Automatic Humidifier Operation Installation Instruction for TMV2 Two Stage Thermostat Model Optional ControllersEconomy Display Mode Wiring Wiring DiagramGeneral Information MaintenanceOver Temperature Cut Out Paint Curing First FiringMain Burner Drawing Cleaning Main Burner Front door removal drawing Glass CleaningGlass Assembly Replacement General Glass InformationResetting the Heater Unit Operating FaultsLOG Placement Main Convection FAN Surround Installation InstructionsHeat Exchanger Pedestal Installation Instructions Optional Pedestal Assembly InstallationParts List Index Part Number DescriptionGAS Line Rear Parts View Parts View Warranty Terms Purchase Date Dealer Name/PhoneWarranty Parts HOW to Order Repair PartsParts Not Under Warranty Master Parts Distributor ListComfort Systems