Kenwood KRF-X9992D manual Troubleshooting

Troubleshooting

Receiver/Tuner

•The volume setting (-66dB is selected by default)—see “Adjusting the Volume” on pageÊ 10 of this manual

•The tuner’s receiving band (FM is selected by default)— see “Tuner” on pageÊ 50 of this manual

•The tuner’s frequency (87.5MHz is selected by default)— see “Tuner” on pageÊ 50 of this manual

•The tuner’s preset memory—you will need to reset your stored radio stations (see Chapter Two of the Connections and Setup Guide)

•The surround setting—see “What are Listen Modes?” on pageÊ 16 of this manual.

•The speaker settings—you will need to reset your speaker settings ( see Chapter Two of the Connections and Setup Guide)

4.Reset the cleared settings before operating the receiver again.

The sound is distorted, and the CLIP indicator on the receiver’s front panel flashes red continually, or stays red for more than 1 second at a time

Lower the analog input level for the source device you’re lis- tening to. (Setting the proper input level eliminates distortion that occurs if a source device’s output level is too high. When this happens, the front panel CLIP indicator will flash red continually or remain red for periods of 1 second or longer. Occasional brief flashing of the CLIP indicator is okay).

1.Select the icon for the source device. For CD1, Video2, Video3, and Video 4, also select the Input Analog icon.

80 Audio-Video Receiver KRF-X9992D