
Chapter Two : Setting Up PowerTouch
After you install the batteries or reset PowerTouch, you need to calibrate the touch screen. The touch screen responds to pressure from the included stylus or your finger:
If you are replacing batteries and complete the battery replacement within 3 minutes, you do not need to calibrate the screen; calibration is stored in memory.
If the screen’s performance begins to change, you can recalibrate it without resetting PowerTouch by
pressing on the Setup Preference menu. For more information about accessing this menu, see “Identifying Devices For PowerTouch Control” on pageÊ 37.
Calibrating the Touch Screen
To calibrate the touch screen, use the stylus to touch the center of each of the calibration points displayed
When you touch each calibration point, you should hear a beep and see the next point, indicating that area of the screen is now calibrated. If you do not hear a beep, touch the calibration point until you do.
The touch screen is sensitive to pressure, not to movement. Press firmly but gently on any touch screen element. The screen will not respond if you simply brush the stylus or your finger along the surface.
Audio-Video Receiver KRF-X9992D
Resetting PowerTouch
If you want to reconfigure PowerTouch, you can reset it. You do not need to do this unless you experience a problem.
1. | Open the cover. |
2. | RemoteSetup |
Use the stylus to press the blue button at the | |
| bottom of the battery case: |
33
The items you set up in this chapter will remain in PowerTouch. If you want to make it to the factory– set default condition, please follow the instructions on page 78 of the Users’ Guide.