Troubleshooting
Sound
Sound
I don’t hear any sound at all
Check that:
•The volume is set at the proper level. See “Adjusting the Volume” on pageÊ 10 of this manual.
•Mute is OFF. If the MUTE indicator on the front of the receiver is blinking, MUTE is ON. See “Muting Sound” on pageÊ 15 of this manual.
•The proper input (e.g., CD player, Tuner, etc.) has been selected on the PowerTouch. See “How Do I Operate De- vices?” on pageÊ 26 of this manual.
•The CD2/Tape2 monitor input has not been selected. (If it has, the CD2/Tape2 monitor indicator on the receiver’s front panel will be lit). See “What’s on the Front Panel of Your Kenwood Audio - Video Receiver?” on pageÊ 2 of this manual.
•The input mode matches the input signal (e.g., analog vs. digital) that has been set. See “Switching to Analog Input” on pageÊ 21 of this manual.
•The correct Listen Mode (e.g., Auto) has been set for the digital input. See “What are Listen Modes?” on pageÊ 16.
•The correct speakers have been activated. See “Turning the Speakers On” on pageÊ 10 of this manual.
I can’t hear sound from one or more of the speakers, or the sound is abnormally low
Check that:
•All of the speaker wires are connected tightly, not short circuited. See Chapter One of the Connections and Setup Guide.
•All of the speakers have been activated in the Setup Speakers menu. See Chapter Two of the Connections and Setup Guide.
72 |
