Kenwood KRF-X9992D manual SP Distance, SP Level

Remote Setup

Chapter Two : Setting Up PowerTouch

80Hz in that channel is left in that speaker in all listening modes. Full-range speakers capable of this level of bass performance are very uncommon, and are almost always too large to be used as center or surround speakers.

If you set your left and right front speakers to Lrg and have a subwoofer in the system, the subwoofer will only receive bass in Stereo mode and during Dolby Digital and MPEG programs. In Dolby Pro Logic, Dolby 3 Stereo, and DSP modes, the subwoofer will not receive any signal at all.

c.If you set your left and right front speakers to Lrg and want to send bass to the subwoofer in

all Listen modes, touch until “On”

36	appears above the button. In Dolby Pro Logic,
	Dolby 3 Stereo, and DSP modes SW Re-Mix
	mixes some of the bass from your left and
	right front speakers back into your subwoofer.
	If you set your left and right front speakers to
	Nml, SW Re-Mix does not function.

d.Touch to save your settings.

e.Touch to move to the next speaker setting

or touch to return to the Surround menu.

If your front speakers are set to Nml, you can only set your center and surround speakers to Nml (or OFF).

If you turn off the subwoofer, your front speakers are automatically set to Lrg. You may not set them to Nml.

SP Distance

1.Measure the distance from each speaker to the seat you most often use and note it below:

Speaker Distance (ft or m)

left front

center

right front

left surround

right surrond

subwoofer

2.If you are not already there, touch on the Setup Surround menu to open the Speaker Distance menu:

3.Touch or to set the distance for the left front speaker.

4.Touch or to select the next speaker.

5.Repeat steps 3 and 4 for each speaker.

6.Touch to move to the next speaker setting or

touch to return to the Surround menu.

Audio-Video Receiver KRF-X9992D

SP Level

In this step you will use your ears to balance the volume level of all the system’s speakers except the subwoofer for your room and listening position. (To set the subwoofer level, see “Setting the Subwoofer Level” on pageÊ 37.) When all the speakers are set at the same volume level, your system will create a more realistic, spacious surround sound environment.

1.Eliminate as many external noise sources as possible.

2.Sit in the place where you and your guests are most likely to sit while watching movies or listening to music.

3.If you are not already there, touch on the Setup Surround menu to open the Speaker Level menu:

4.Touch until the Test Tone display reads “Manu”.

5.The receiver’s master volume will become 0 dB, and test noise will play from the left front speaker. Please note that the test tone is quite loud.