
Chapter One : Connecting Your Devices |
|
Connecting Your Laser Disc Player (without AC-3 RF Output), continued
Connections
Do not plug in the receiver to AC power until you have connected all your devices.
These instructions describe how to connect a laser disc player with a PCM Digital Output. If your player has a Dolby Digital
The instructions in this section show one of several possible variations on connecting your laser disc player. For further assistance on optional configura- tions, contact the store where you purchased your receiver.
To Connect a PCM Digital Output Laser Disc Player:
1.Review the information under “Before You Begin” on pageÊ 1. It contains important notes about the types of video connections you can make.
2.Look at the digital connection on your laser disc player. Use the table below to choose a jack set:
If your digital | Choose this jack |
cable is... | set... |
|
|
optical | VIDEO4 |
|
|
coaxial | VIDEO2 or 3 |
Note that the jack sets are linked, even though they are not adjacent. You must connect all of the cables from your laser disc player to a linked jack set. If you connect the analog cables to VIDEO2 and the digital optical cable to VIDEO4,Ê your laser disc player will not work correctly.
3.Connect the audio cables from the laser disc player’s Audio OUT jacks to the receiver’s AUDIO jacks as shown to the left.
4.Connect the video cable from the laser disc player’s Video OUT jack to the receiver’s VIDEO PLAY IN jack as shown to the left.
5.Connect the digital cable (either coaxial or optical) from the laser disc player’s digital jack to the appropriate digital jack on the receiver as shown to the left. Your laser disc player supports only one of the digital connection
If you use the optical digital cable, be sure to remove the protective cover from the optical jack before connecting.
6.Go to “Noting Your Devices” on pageÊ 3 and note which jacks you used to connect your laser disc
player. In addition, note the brand name and | 27 |
model number of the laser disc player. |