
Receiver/Tuner
Receiver/Tuner
My receiver won’t turn on and the STANDBY indicator is flashing
Your receiver is in the “protection” mode.
Check that:
•The speaker system’s impedance is not too low. See Chapter One of the Connections and Setup Guide.
•The speaker wires are not
•Turn off the receiver, disconnect the positive and negative speaker wires of the RIGHT FRONT speaker from the receiver, and turn the receiver back on.
•If the STANDBY indicator stops flashing, replace this wire.
•If the STANDBY indicator does not stop flashing, turn off the receiver, reconnect the speaker wires, and repeat the first step for the next speaker.
•Continue until you have isolated and replaced the shorted wire.
•See Chapter One of the Connections and Setup Guide.
If none of the above solutions work, reset the microprocessor:
1.Turn the receiver off. (The Power button is OFF position.)
2.Press ON/STANDBY button while pressing and holding the Power button.
3.Continue to hold the Power button for more than 1 second. The following settings are cleared:
•The device set as input (Tuner is selected by
Troubleshooting
79 |