
Chapter One : Connecting Your Devices
Do not plug in the receiver to AC power until all connections have been made.
To Connect Front Speakers Only:
If you only intend to listen to stereo sound (as opposed to surround sound), you may simply connect a single pair of speakers. To do so:
1.Loosen the speaker wire binding posts.
2.Insert the wire from the positive jack on the RIGHT FRONT speaker into the
3.Repeat step 2 for the positive and negative wires on the LEFT FRONT speaker.
Connecting Your Speakers, continued
To Connect Front and Surround Sound Speakers:
To listen to the full surround sound that this receiver can put out, connect front speakers, center, left surround, and right surround speakers. To do so:
1.Loosen the speaker wire binding posts.
2.Follow the steps under “To Connect Front Speakers Only” on this page to connect the RIGHT and LEFT FRONT speakers.
3.Insert the wire from the positive jack on the CENTER speaker into the
Tighten the post. Repeat for the negative wire.
4.Insert the wire from the positive jack on the RIGHT SURROUND speaker into the
5.Repeat step 4 for the positive and negative wires on the LEFT SURROUND speaker.
Audio-Video Receiver KRF-X9992D
What if I Have a Powered Subwoofer?
Simply connect the subwoofer’s audio cable to the receiver’s subwoofer PRE OUT jack as shown to the left.
Never short circuit the + and - speaker wires.
Do not switch the left and right speaker wires or swap the + and - wires on the binding posts.
The speakers must have a nominal impedance of between 6Ω and 16Ω.
Using Speaker Wire
5
1. Loosen post
2. Insert wire
3. Tighten post
Connections