Operation
C.
Flame Action Control
Turn the flame action control knob to adjust the flame speed control to the desired level.
D. Manual Selection Switch
Operates the electric fireplace manually. Pressing the switch up (“ “ position) once turns on the electric fireplace and activates Level 1, twice activates Level 2, three times activates Level 3.
Pressing the switch down (“
“ position) turns the electric fireplace OFF.
Level 1 
: The flame effect is turned on and the first red indicator light illuminates.
Level 2 
: The flame effect remains on, the heater is activated to the low heat setting, and the first and second red indicator lights illuminate.
Level 3 
: The flame effect remains on, the heater is set to the high heat setting, and all three red indicators illuminate.
Resetting the Temperature Cutoff Switch
Should the heater overheat, an automatic cut out will turn the heater off and it will not come back on without being reset. It can be reset by switching the Main On/Off Switch to Off and waiting five (5) minutes before switching the unit back on.
CAUTION: If you need to continuously reset the heater, unplug the unit and call Dimplex North America Limited at
Remote Control
The fireplace is supplied with a radio frequency remote control. This remote control has a range of approximately 50 feet (15.25 m), it does not have to be pointed at the fireplace and can pass through most obstacles (including walls). It is supplied with one of 2,178 independent frequencies to prevent interference with other units. The frequency designation is indicated on the back of the transmitter.
Remote Control Initialization/ Reprogramming
Follow steps 1 through 6 to
11