Operation
three red indicators illuminate.
Battery Replacement
(Figure 4)
To replace the battery:
1.Slide battery cover open on the hand held transmitter.
2.Correctly install one (1) 12 Volt (A23) battery in the battery holder.
Maintenance
WARNING: Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock or damage to persons.
Light Bulb Replacement
Allow at least five (5) minutes for light bulbs to cool off before touching bulbs to avoid accidental burning of skin. Light bulbs need to be replaced when you notice a dark section of the flame or when the clarity and detail of the log exterior disappears. There are four (4) bulbs under the log set which generate the flames and embers and two (2) bulbs up, in behind the grill that illuminate the interior of the fireplace.
3. Close the battery cover.
Battery must be recycled or disposed of properly. Check with your Local
Authority or Retailer for recycling advice in your area.
Required tools: Phillips #2 screw driver, Slot screw driver.
Approximate time: 15 minutes to change upper and lower light bulbs.
Helpful Hints
It is a good idea to replace all light bulbs at one time if they are close to the end of their rated life. Group replacement will reduce the number of times you need to open the unit to replace light bulbs.
To open the light bulb area:
1.Remove the trim by turning the retaining fasteners counterclockwise 1/4 turn until the trim releases from
13