Operation
initialize your fireplace for the first time. This procedure is also required every time there is a loss of power to the remote control in the fireplace (I.E. power failure, breaker tripped, main power switch is turned off).
1.Ensure that power is supplied through the main service panel.
2.Access the manual controls,
(remove glass doors or pull grill down if applicable) pull the right side steel curtain to the outside of the unit (if applicable).
3.Locate manual controls.
4.Activate main power switch.
5.Press and hold the ON switch
marked “ ” for five (5) seconds (red indicator light will flash).
6.Press the ON button located on the remote control transmitter.
This will synchronize the remote control transmitter and receiver.
Remote Control Usage
The remote control operates the fireplace levels sequentially. The level is increased every time the ON button on the transmitter is
Figure 4
ON
Button
OFF
Button
Battery
Battery
Cover
pressed.
The fireplace can be turned off at any point by pressing the OFF button on the remote control transmitter.
Level 1 
: The flame effect is turned on and the first red indicator light illuminates.
Level 2 
: The flame effect remains on, the heater is activated to the low heat setting, and the first and second red indicator lights illuminate.
Level 3 
: The flame effect remains on, the heater is set to the high heat setting, and all
12 | www.dimplex.com |