Fireplace Installation
1.Make sure the unit’s Main On/Off switch is switched Off (refer to operating instruction section).
2.Plug the unit into a 15
Amp/120 Volt outlet. If the cord does not reach, you may use an extension cord rated for a minimum of 1875 Watts.
3.Push the fireplace into the opening being careful not to damage the base of the mantel or cabinet so that the fireplace is flush with the mantel or cabinet.
4.Level the unit with shims if necessary (not provided).
5.Install the trim onto the fireplace (refer to trim installation instructions).
WARNING: Ensure the power cord is not installed so that it is pinched or against a sharp edge and ensure that the power cord is stored or secured to avoid tripping or snagging to reduce the risk of fire, electric shock or injury to persons.
Operation
Figure 3
D | B | C |
| A |
A. Manual On/Off Switch | B. | Light Dimmer | ||
The fireplace has a manual power On/Off switch located on the control panel of the fireplace. Toggle the switch to turn the fireplace on and off.
Turn the flame brightness control knob to increase or decrease the brightness of the flame and embers.
10 | www.dimplex.com |