Enviro VENTED GAS FIREPLACE HEATER owner manual Secondary Installation, Ascot Burner Tray

Page 31

Secondary Installation

INSTALLATION OF LOG SET AND EMBERS:

The placement of the logs is not arbitrary. If they are positioned incorrectly, the flames can be “pinched” and will not burn correctly. The burner come with four (4) locator pins (see Figure 48), and the bottom

logs have ledges which make alignment easier. Using the pictures provided, carefully set the logs in place.

NOTE: The logs are fragile and should be handled gently.

CAUTION: Use only the type of ember material supplied with this appliance. Due to the irregular size of the ember material there may be more than required. The use of other foreign materials on the burners may create dangerous conditions.

If over time, through cleaning and servicing, these embers require replacement, contact the nearest ENVIRO dealer for replacement embers.

1.Carefully remove logs from box. Check to ensure there is no damage. It is very important to install all logs in their proper position to insure safe,

optimum operating conditions.

2.Place the log set into the firebox. Locate each log by seating it down onto the burner tray support pins. Follow the figures to the right for proper log placement.

Figure 48. Ascot Burner Tray.

Figure 49. Log Placement Step 1.

Figure 50. Log Placement Step 2.

31

Image 31
Contents Consumer InstallerGeneral Safety PrecautionsTable of Contents Vented GAS Fireplace Heater Ascot DV NG/LPG Codes And ApprovalsThis Enviro Ascot Fireplace Dimensions of the Ascot SpecificationsOperating Instructions For Your Safety Read Completely Before OperatingPilot flame Component Sound & ReasonSIT Valve on Ascot Maintenance And ServiceRemoving inner glass door FireboxConversion Kit Installation Kit Parts ListRemoving valve screw Qualified Installers only Initial InstallationRound Support Vent Termination Restrictions KIT Components Installation InstructionsManufacturer Trade Name Nominal Sizes Installation of Fireplace Horizontal Vent Kit4DSC Vent Restrictor Setting Twist-Lock Connection Cm at top, 11⁄2 3.8 cm at sides, 11⁄2 3.8 cm at bottomInstalling Vent Cap with Vinyl Siding Stand-Off Straight Through Wall Installation Support straps outwards, and push Sections until the height Multi-Story Vent Pipe Installation A. Installations InstallationWiring Diagram Canadian InstallationsSpillage Test Venting of a Fireplace Fitted with the Drafthood AdaptorSpill Switch Replacement Automatic Safety Shut DownOptional Finishing Seal Plate To Test Valve Pressures GAS Line ConnectionRecommended Thermostat Wire Size Ascot Burner Tray Secondary InstallationEmber Placement Installation of Optional Blower Problem Possible Cause Solution Trouble ShootingReference Description Part Number Parts ListCast Description Reference Cast Description Part Number DiagramParts To the Dealer WarrantyWarranty Warranty Installation Data Sheet