Enviro VENTED GAS FIREPLACE HEATER owner manual Installation of Optional Blower

Page 33

Secondary Installation

Important note: When the unit is turned on for the first time, It should be turned onto high without the fan on for the first 4 hours. This will cure the paint, logs, gasket material and the other products used in the manufacturing process. It is advisable to open a window or door, as the unit will start to smoke and can irritate some people. After the unit has gone through the first burn turn the unit off including the pilot, let the unit get cold then remove the glass door and clean it with a good gas fireplace glass cleaner, available at your local ENVIRO dealer.

See Routine MAINTENANCE AND SERVICE on how to remove door to clean glass.

Figure 54. Ascot Burning.

CAUTION: NEVER OPERATE THIS APPLIANCE WITH THE DOOR REMOVED.

INSTALLATION OF OPTIONAL BLOWER:

���� � ���� ��

��� �����������

������

������ ������

��� ����������

��� �����������

������ ������

�������� ���

Figure 55: Optional Fan Kit Installation.

Remove the pre-assembled blower from the packaging. Inspect the blower for damage. If damage is noticed call your dealer, distributor or courier company and have components replaced.

Place the fan assembly behind the unit and secure with the two screws provided (as shown in Figure 55).

Remove the fan controller, mounting box and install fan controller. Neatly dress the wires from the fan assembly to the fan controller.

Install the fan temperature sensor with the two (2) screws provided.

Plug the fan assembly into the wall outlet and turn the unit on to ensure fan operation.

33

Image 33
Contents Consumer InstallerGeneral Safety PrecautionsTable of Contents Codes And Approvals Vented GAS Fireplace Heater Ascot DV NG/LPGThis Enviro Ascot Fireplace Dimensions of the Ascot SpecificationsOperating Instructions For Your Safety Read Completely Before OperatingPilot flame Component Sound & ReasonSIT Valve on Ascot Maintenance And ServiceRemoving inner glass door FireboxConversion Kit Installation Kit Parts ListRemoving valve screw Qualified Installers only Initial InstallationRound Support Vent Termination Restrictions KIT Components Installation InstructionsManufacturer Trade Name Nominal Sizes Installation of Fireplace Horizontal Vent Kit4DSC Vent Restrictor Setting Twist-Lock Connection Cm at top, 11⁄2 3.8 cm at sides, 11⁄2 3.8 cm at bottomInstalling Vent Cap with Vinyl Siding Stand-Off Straight Through Wall Installation Support straps outwards, and push Sections until the height Multi-Story Vent Pipe Installation Wiring Diagram InstallationCanadian Installations A. InstallationsSpillage Test Venting of a Fireplace Fitted with the Drafthood AdaptorAutomatic Safety Shut Down Spill Switch ReplacementOptional Finishing Seal Plate To Test Valve Pressures GAS Line ConnectionRecommended Thermostat Wire Size Ascot Burner Tray Secondary InstallationEmber Placement Installation of Optional Blower Problem Possible Cause Solution Trouble ShootingReference Description Part Number Parts ListCast Description Reference Cast Description Part Number DiagramParts To the Dealer WarrantyWarranty Warranty Installation Data Sheet