MAINTENANCE
Installing Glass
1)Install both center and side glass onto extrusions as per diagram.
2)Place glass assembly into door frame.
3)Install retainers by placing 1 drop of glue where previously glued and put in place.
4)Install side retainers.
5)Install door catch plate.
6)Install the 24 nuts loosely, do not tighten yet.
7)Tighten side panels nuts using the following procedure:
put glue on the screws. Replace the door gasket, the two ends butt tight together on the bottom edge of the door.
8)Replace door on the stove and check the seal.
To Remove U38 Fan:
1)Unplug or disconnect power source to stove.
2)Remove all logs and the rear log support, then remove the 10 screws holding the access panel in place, see Diagram 1. (Fan is also accessible by opening the right side door. See Diagram 2).
3)Unclip the black and white wires from the fan motor.
a.tighten top & bottom outside corner nuts (2)
b.tighten inside nuts (3)
c.tighten top & bottom inside corners
(2)
8)Tighten the 10 nuts on center glass retainer.
9)Repeat step 7 for other side panel.
10)Replace new gasket by gluing it in place.
11)Install door onto stove and check the seal.
PANELDOOR
1)Remove the door from the unit and place on a soft surface to prevent scratching.
2)Pull out the door gasket.
3)Remove the nuts holding the glass retainers in place.
4)Remove the glass retainers (sides, top and bottom) and the door catch plate.
5)Replace the glass. The glass must have gasketing around it.
6)Reverse the previous steps, replace the retainers and fasten with the nuts but do not overtighten, as this can break the glass. Note: the door catch plate fits on top of the left side retainer.
7)Put gasket glue on the retainers, but do not
FAN MAINTENANCE
If your fan requires maintenance or replace- ment, access to the fan is through the access panel on the rear wall of the firebox.
Note: The unit MUST NOT be operated without the fan access panel se- curely in place and correctly sealed.
IMPORTANT: These fans collect a lot of dust from within your home. Ensure you maintain these fan mo- tors on a regular basis by vacuum- ing out the fan squirrel cages, around the motor, and around the grills on the back of the stove.
IMPORTANT
Disconnect power supply
before servicing
WARNING: Electrical Grounding In- structions This appliance is equipped with a three pronged (grounding) plug for your protection against shock hazard and should be plugged directly into a properly grounded
Diagram 1
Diagram 2
4)Lift fan off of the 2 pins, tip back and pull through firebox opening. Disconnect the green ground wire from the left side of the fan as soon as you can reach it.
Replacing U38 Fan:
Reverse the above steps (1 - 4). If necessary install a new gasket before replacing the fan access panel. Make sure the fan wires and the ground wire are reattached.
18 | Regency U38 ULTIMATE Freestanding Gas Stove |