Regency F37-LPG Warranty, Conditions, Exclusions, General, Western Australia Eastern Australia

Page 27

WARRANTY

Regency® Fireplace Products are designed with reliability and simplicity in mind. In addition, our internal Quality Assurance Team carefully inspects each unit thoroughly before it leaves our door. FPI is pleased to extend this limited lifetime warranty to the original purchaser of a Regency® Product.

The Warranty: Lifetime

Covered under the agreement are the following components: Combustion chamber, heat exchanger, burner tubes, logs, embers, glass (thermal breakage) and all gold plating against defective manufacture.

NOTE: Gold Plated Barcelona Front - slight imperfections in the gold plating are due to the plating process and are not considered defects.

The above will be covered for parts and labour for the fi rst fi ve years and parts only thereafter.

Electrical components such as blowers, switches, wiring, thermodiscs, remote control, thermopiles, thermocouples and gas valves are covered for one year from the date of purchase.

The warranty on brass parts is for one year, no labour. The brass is not warranted against tarnishing.

Conditions:

All installations must be performed by a qualifi ed gas fi tter and installed according to all applicable local and national codes. Also, all service work must be carried out by a qualifi ed gas service person provided by the selling dealer. It is the responsibility of the installer to ensure that the appliance is fi ring as per rating plate. Any part or parts of this unit which in our judgement show evidence of such defect will be repaired or replaced at Regency®'s option, through an accredited distributor or agent provided that the defective part be returned to the distributor or agent Transportation Prepaid, if requested. In areas where there is not an approved service agent or the closest approved service agent is situated more than twenty-fi ve (25) kilometres from the installation, Australian Heating Distributors are not obliged to arrange warranty repairs and travel and/or additional labour charges will apply.

Exclusions:

This limited Lifetime Warranty does not extend to or include paint, door or glass gasketing or trim. It does not cover installation and operational related problems such as over-fi ring, downdrafts or spillage caused by environmental conditions, nearby trees, buildings, hilltops, mountains, inadequate fl ueing or ventilation, excessive offsets, negative air pressures caused by insuffi cient make up air, mechanical systems such as furnaces, fans, clothes dryers etc.

The warranty does not extend to any part or parts which show evidence of misuse or abuse, neglect, accident, lack of maintenance, or improper installation.

Products made by other manufacturers and used in conjunction with the operation of this appliance without authorization from Regency®, may nullify your warranty on this product.

FPI Ltd., shall in no event be liable for any special, indirect consequential damages of any nature whatsoever which are in excess of the original purchase price of the product. Any alteration to the unit which causes sooting or carboning that results in damage to the exterior facia is not the responsibility of FPI.

General:

It is essential that all submitted claims provide all of the necessary information including purchase date, serial #, type of unit and part or parts requested.

SUBJECT TO CHANGE.

DISTRIBUTORS:

Western Australia

Eastern Australia

 

AUSTRALIAN HEATING DISTRIBUTORS

FIREPLACE PRODUCTS AUSTRALIA PTY. LTD.

 

31 CLUNE STREET

21-23 SOUTH LINK BLVD.

 

BAYSWATER, WA 6053

DANDENONG, VIC 3175

SERVICE AGENTS:

HEARTH HOUSE SERVICE

 

 

 

 

31 CLUNE STREET

 

 

BAYSWATER, WA 6053

 

NOTE: PLEASE RETAIN YOUR INVOICE AS PROOF OF PURCHASE FOR WARRANTY VERIFICATION

INCORRECT INSTALLATION OR GAS PRESSURE SETTINGS ARE NOT COVERED BY WARRANTY

A SERVICE OR CALLOUT FEE WILL BE CHARGED IN THESE CIRCUMSTANCES.

F37 Regency® Rear Flued Room Sealed Freestanding Gas Heater

27

Image 27
Contents Please Keep These Instructions For Future Reference ManualTo the New Owner Table of Contents Data Badge Before YOU Start InstallationSpecifications General Safety InformationInstallation Checklist Locating Your Regency GAS StoveClearances to Combustibles Clearance k in mm Exterior Flue Termination LocationsFlueing Flueing Installation PrecautionsSafety Precautions For the Installer Planning Your Flueing InstallationOffset to Vertical Terminations Vertical Terminations Using Dura-Vent Flueing SystemFlueing Arrangements Vertical Terminations Straight Vertical TerminationsHorizontal Installations Optional ComponentsSnorkel Terminations Hint Apply sealant to female end Below Grade Snorkel InstallationGAS Connection Vertical Termination with CO-LINEAR Flex SystemConversion Kit Contains Qty Description Aeration Adjustment LOG SET InstallationNG 10mm open LPG 10mm open Door Installation Packaged Separately Optional Wall Thermostat TestingLouvre Installation GAS Pipe PressureFinal Check Optional Remote ControlWiring Thermostat Wire TableOperating Instructions Copy of the Lighting Plate Instructions For Your Safety Read Before LightingMaintenance Never operate your unit with broken glass Latch AdjustmentGlass Replacement Installing GlassReplacing Fan FAN MaintenanceRemoving Valve To remove fanMaintenance Main Assembly Parts ListBurner & LOG Assembly Door Assemblies General WarrantyConditions Exclusions

F37-LPG, F37-NG specifications

The Regency F37-LPG and F37-NG are contemporary gas fireplaces that represent a perfect blend of modern design and efficiency, catering to both propane (LPG) and natural gas (NG) needs. These models are engineered to enhance living spaces while providing optimal warmth and comfort. Their elegant appearance and advanced technologies make them a popular choice for homeowners seeking an aesthetically pleasing and functional heating solution.

One of the key features of the Regency F37 series is its large viewing area, which allows for an unobstructed view of the flames, creating a visually stunning focal point in any room. The fireplace's design includes a clean front and minimalistic aesthetics that can complement various interior styles, from traditional to contemporary. The F37 offers an array of customizable options, including various finishes, decorative media, and fireplace configurations.

Technologically, the Regency F37 is equipped with an advanced burner system that enhances the flame presentation while maintaining high efficiency. The system produces realistic flames and glowing embers, emulating the look of a traditional wood-burning fire without the hassle of real wood. Additionally, the fireplaces feature a precise control system, allowing users to adjust the flame height and heat output according to their preferences.

In terms of efficiency, the F37 series boasts impressive energy ratings, ensuring that homeowners can enjoy warmth without incurring excessive costs. The fireplaces are designed with an emphasis on heat retention, utilizing modern insulation and venting technologies that promote optimal performance. With a focus on environmental sustainability, Regency ensures that their units produce lower emissions, making the F37 series an eco-friendly choice for heating.

The ease of installation is another significant advantage of the Regency F37, with flexible venting options designed to accommodate various home layouts. Whether it is an existing space or a new construction, the fireplace can be adapted to meet specific design and functionality needs.

In summary, the Regency F37-LPG and F37-NG are exceptional gas fireplaces that combine striking design with cutting-edge technology. Their large viewing areas, customizable options, high efficiency, and eco-friendly features make them an excellent addition to any home, ensuring comfort and style for years to come.