Regency F37-NG, F37-LPG installation manual Installation Checklist, Locating Your Regency GAS Stove

Page 6

INSTALLATION

Make it a practice to have all of your gas appliances checked annually.

13)Do not slam shut or strike the glass door.

14)Under no circumstances should any solid fuels (wood, paper, cardboard, coal, etc.) be used in this appliance.

15)The appliance area must be kept clear and free of combustible materials, (gases and other fl ammable vapours and liquids).

INSTALLATION

CHECKLIST

1)

Locate your gas stove. Refer to the following

 

sections where applicable:

 

a. Clearances to Combustibles

 

b. Exterior Flue Termination Locations

 

c. Planning Your Flue Installation

 

d. Flueing

 

e. Flueing Installation Precaution

2)

Install flueing. Check all fluing requirements.

 

See "Flueing" to "Vertical Termination with

 

Co-Linear Flex System" sections.

3)

Make gas connections. Refer to the "Gas

 

Connection" section.

 

Test the pilot. Must be as per diagram in the

 

"Maintenance Instruction" section.

4)

If necessary, convert from NG to LPG.

 

Refer to "Conversion Kit from NG to LPG"

 

section.

5)

Install standard and optional features. Refer

 

to the following sections where applicable.

 

a. Log Set Installation

 

b. Door Installation

 

c. Louvre Installation

 

d. Optional Wall Thermostat

 

e. Optional Remote Control

CAUTION: Any alteration to the product that causes sooting or carboning that results in damage is not the responsibility of the manufacturer.

LOCATING YOUR

REGENCY GAS STOVE

When selecting a location for your stove, ensure that the clearances listed above are met as well as ensuring that there is adequate accessibility for servicing and proper operation.

See the "Exterior Flue Termination Locations" section for Flue Termination requirements.

ThisapplianceisListedforbedroom installations when used with a Listed Millivolt Thermostat. Some areas may have further requirements, check local codes before installation.

This appliance is Listed for Alcove installations, maintain minimumAlcove clearances as follows, minimum ceiling height of 1.7m, minimum width of 1.0m and a maximum depth of 0.9m.

A)Cross Corner

B)Flush with Wall/Alcove

C)Flat on Wall Corner

D)Flat on Wall

This unit can be installed on a solid combustible surface like a wood fl oor. This unit can also be installed directly on carpeting or vinyl when the bottom pedestal cover plate (provided with unit) is installed.

Use the minimum clearances shown in the diagrams below:

F37-NG & F37-LPG Clearances

A Side Wall to Unit

190 mm

B Back Wall to Unit

76 mm

E Side Wall to Unit

114 mm

F37-NG & F37-LPG

Reference Dimensions

C Floor to Flue Centerline

635 mm

D Side Wall to Flue Centerline521 mm

Minimum ceiling height is

914mm from top of unit.

6)

Test Gas Pressure. Refer to the "Gas Pipe

 

Pressure Testing" section.

7)

Final check. Refer to the "Final Check" sec-

 

tion.

Before leaving this unit with the customer, the installer must ensure that the appliance is fi r- ing correctly and operation fully explained to customer.

This includes:

1)Clocking the appliance to ensure the correct fi ring rate (rate noted on label) after burning appliance for 15 minutes.

2)Ifrequired,adjustingtheprimaryairtoensure that the fl ame does not carbon. First allow the unit to burn for 15-20 min. to stabilize.

CLEARANCES TO

COMBUSTIBLES

The clearances listed are MINIMUM distances. Measure the clearance to both the appliance and thechimneyconnector.Thefarthestdistanceis correct if the two clearances do not coincide. For example, if the appliance is set as indicated in one of the diagrams but the connector is too close, move the stove until the correct clearance to the connector is obtained.

This appliance may be installed only with the clearances as shown in the situations pictured.

Do not combine clearances from one type of installation with another in order to achieve closer clearances.

COMBUSTION AND VENTILATION AIR

The combustion air from this appliance is drawn from outside the building through the outer fl ue.

Extra provision for combustion air inside the room is not required.

6

F37 Regency® Rear Flued Room Sealed Freestanding Gas Heater

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Manual Please Keep These Instructions For Future ReferenceTo the New Owner Table of Contents Data Badge General Safety Information InstallationSpecifications Before YOU StartInstallation Checklist Locating Your Regency GAS StoveClearances to Combustibles Exterior Flue Termination Locations Clearance k in mmPlanning Your Flueing Installation Flueing Installation PrecautionsSafety Precautions For the Installer FlueingStraight Vertical Terminations Vertical Terminations Using Dura-Vent Flueing SystemFlueing Arrangements Vertical Terminations Offset to Vertical TerminationsHorizontal Installations Optional ComponentsSnorkel Terminations Below Grade Snorkel Installation Hint Apply sealant to female endVertical Termination with CO-LINEAR Flex System GAS ConnectionConversion Kit Contains Qty Description Aeration Adjustment LOG SET InstallationNG 10mm open LPG 10mm open Door Installation Packaged Separately GAS Pipe Pressure TestingLouvre Installation Optional Wall ThermostatThermostat Wire Table Optional Remote ControlWiring Final CheckOperating Instructions For Your Safety Read Before Lighting Copy of the Lighting Plate InstructionsMaintenance Installing Glass Latch AdjustmentGlass Replacement Never operate your unit with broken glassTo remove fan FAN MaintenanceRemoving Valve Replacing FanMaintenance Parts List Main AssemblyBurner & LOG Assembly Door Assemblies Exclusions WarrantyConditions General

F37-LPG, F37-NG specifications

The Regency F37-LPG and F37-NG are contemporary gas fireplaces that represent a perfect blend of modern design and efficiency, catering to both propane (LPG) and natural gas (NG) needs. These models are engineered to enhance living spaces while providing optimal warmth and comfort. Their elegant appearance and advanced technologies make them a popular choice for homeowners seeking an aesthetically pleasing and functional heating solution.

One of the key features of the Regency F37 series is its large viewing area, which allows for an unobstructed view of the flames, creating a visually stunning focal point in any room. The fireplace's design includes a clean front and minimalistic aesthetics that can complement various interior styles, from traditional to contemporary. The F37 offers an array of customizable options, including various finishes, decorative media, and fireplace configurations.

Technologically, the Regency F37 is equipped with an advanced burner system that enhances the flame presentation while maintaining high efficiency. The system produces realistic flames and glowing embers, emulating the look of a traditional wood-burning fire without the hassle of real wood. Additionally, the fireplaces feature a precise control system, allowing users to adjust the flame height and heat output according to their preferences.

In terms of efficiency, the F37 series boasts impressive energy ratings, ensuring that homeowners can enjoy warmth without incurring excessive costs. The fireplaces are designed with an emphasis on heat retention, utilizing modern insulation and venting technologies that promote optimal performance. With a focus on environmental sustainability, Regency ensures that their units produce lower emissions, making the F37 series an eco-friendly choice for heating.

The ease of installation is another significant advantage of the Regency F37, with flexible venting options designed to accommodate various home layouts. Whether it is an existing space or a new construction, the fireplace can be adapted to meet specific design and functionality needs.

In summary, the Regency F37-LPG and F37-NG are exceptional gas fireplaces that combine striking design with cutting-edge technology. Their large viewing areas, customizable options, high efficiency, and eco-friendly features make them an excellent addition to any home, ensuring comfort and style for years to come.
Top Page Image Contents