Regency P40-LP, P40-NG Operating Instructions, First Fire, Lightingshutdown Procedure Procedure

OPERATING INSTRUCTIONS

OPERATION

OPERATING

INSTRUCTIONS

1)Read and understand these instructions before operating this appliance.

2)Check to see that all wiring is correct and enclosed to prevent possible shock.

3)Check to ensure there are no gas leaks.

4)Make sure the glass in the door frame is properly positioned. Never operate the appliance with the glass removed.

5)Verify that the venting and cap are unobstructed.

6)Ensure that the brick panels are installed.

7)Verify log placement. If the pilot cannot be seen when lighting the unit, the logs have been incorrectly positioned.

8)The unit should never be turned off, and on again without a minimum of a 60 second wait.

1)Push in gas control knob slightly and turn clockwise to “OFF”. Knob cannot be turned from“PILOT”to“OFF”unlessknobispushed in slightly. Do not force.

2)Wait fi ve (5) minutes to clear out any gas.

3)Turn knob on gas control counterclockwise to “PILOT”.

4)Push in control knob all the way and hold in until the pilot lights up. Continue to hold the control knob in for about 20 seconds after the pilot is lit. Release knob and it will pop back up. Pilot should remain lit. If it goes out, repeat steps 1) to 4). If knob does not pop up when released, stop and immediately call your service technician or gas supplier. If the pilot will not stay lit after several tries, turn the gas control knob to “OFF” and call your service technician or gas supplier.

5)Turn gas control knob counterclock-wise to “ON”.

6)Turn the unit on.

NOTE: If using the remote control refer to the FireWizard manual for instructions.

FIRST FIRE

DO NOT BURN THE APPLIANCE WITHOUT THE GLASS FRONT IN PLACE.

The FIRST FIRE in your heater is part of the paint curing process. To ensure that the paint is properly cured, it is recommended that you burn your fi replace for at least four (4) hours the fi rst time you use it with the fan on.

When fi rst operated, the unit will release an odour caused by the curing of the paint and the burning off of any oils remaining from manufac- turing. Smoke detectors in the house may go off at this time. Open a few windows to ventilate the room for a couple of hours. The glass may require cleaning.

NOTE: The main burner will always start on "HIGH" and resume it's last setting after 20 seconds of operation.

NOTE: When the glass is cold and the appliance is lit, it may cause condensation and fog the glass. This condensation is normal and will disappear in a few minutes as the glass heats up.

LIGHTINGSHUTDOWN

PROCEDURE PROCEDURE

DO NOT ATTEMPT TO CLEAN THE GLASS WHILE IT IS STILL HOT!

IMPORTANT

To ignite or reignite the pilot,

you must first release the

tension springs below the door.

Only when the pilot holds, without pressure being applied to the control knob, reapply the tension springs to the door. The unit must not be operated with the tension springs unattached.

IMPORTANT Gas on/off knob cannot be turned from "PILOT" to "OFF" unless it is partially depressed.

Ensure that the 3 way switch on the manual control panel is in the "Remote" position.

1)Press the ON/OFF switch once.

2)The LED will fl ash.

3)Turn the main gas control clockwise to the "OFF" position to turn off the pilot.

4)Turn off all electric power to appliance if service is to be performed.

During the first few fires, a white film may develop on the glass front as part of the curing process. The glass should be cleaned after the unit has cooled down or the film will bake on and become very difficult to remove. Use a non-abrasive cleaner and DO NOTATTEMPT TO CLEAN THE GLASS WHILE IT IS HOT.

Manual Control Panel

3-way Switch

34 Regency® P40 Direct Vent Gas Fireplace