Regency P33-NG4 installation manual 250, 251

Page 30

INSTALLATION

OPTIONAL BRICK

LOG SET INSTALLATION

 

PANELS

D) 251

A) 250

1)Undo the bottom 2 door latches and open and remove glass door. Remove logs.

2)Attach the 2 Rear Brick Retaining clips to the rear wall. Loosen the screws in the top and rear wall of the fi rebox and slide the retaining clips into position (tight against the fi rebox top) and then tighten the screws.

Readtheinstructions belowcarefully and refer to the diagrams. If logs are broken do not use the unit until they are replaced. Broken logs can interfere with the pilot operation.

The 3-digit numbers (i.e. 250) are molded into the rear of each log.

C) 253

B) 254

E) 252

Note: The logs must not be in the unit.

3)Insert the back brick panel by carefully slipping it between the back wall of the fi rebox and the rear log bracket.

4)Put the side panels in next. Slide them in from the front and push them fl at up against the wall. Be very careful not to scratch them on the fi rebox hardware.

Log Kit # 431-930 contains the following pieces:

A)250 Rear Log

B)254 Middle Cross Log

C)253 Front Left Cross Log

D)251 Rear Left Log

E)252 Front Right Cross Log

F)

Embers

902-156

G)

Vermiculite

902-179

H)

Rockwool

902-153

NOTE: If you will be installing the optional Brick Panels, install the Brick Panels prior to installing the logs.

1)Carefully remove the logs from the box and unwrap them. The logs are fragile, handle with care - do not force into position.

2)Sprinkle the vermiculite and embers around the fi rebox base.

Vermiculite Vermiculite Vermiculite

3)Place the Log 250 on the rear log support pins with the fl at side to the back.

4)Place Log 254 on the front right side of the burner. Push the back of the log against the 2 brackets with the notch on the bottom right side of the log fi tting into the right side of the grate.

Notch

254

BracketBracket

250

254

5)Position Log 253 across the cutouts in Logs 250 and 254 with the notch on the left side of the log fi tting into the 2nd grate tab.

Cutouts

5)Slide the Top Brick Panel into position and slide the Top Brick Retaining clips so that they hold the Top Brick Panel in place and tighten down the screws.

250

253

250

254

2nd Grate Tab

30

Regency® P33-4 Zero Clearance Direct Vent Gas Fireplace

Page 29 Page 31
Image 30
Page 29 Page 31
Contents P33-4 Zero Clearance Information for MOBILE/MANUFACTURED Homes After First Sale To the New OwnerTable of Contents Safety Label Safety LabelRequirements MA Code CO DetectorImportant Message InstallationGeneral Safety Information Before YOU StartLocating Your Fireplace Installation ChecklistUnit Dimensions Duct System OptionClearances Mantel LEG ClearancesFraming and Finishing Vertical Termination or Vertical Rise with HorizontalRear Termination Venting Introduction Unit Assembly Prior to InstallationTop Standoff Assembly Top Facing Support Side Nailing StripsExterior Vent Termination Locations VentHeight Meters Minimum Feet RoofPitchAlternate Regency Direct Vent Flex SystemHorizontal Terminations Only Without any joints or seamsInstallation Procedures For Regency Direct Vent System FlexMinimum and Maximum Vent Clearances Thickness inches Required inches Flat Wall InstallationVent Length Max. WallRigid Pipe Venting Components List SV4LB6Rigid Pipe Venting Arrangements Vertical Terminations Propane & Natural GasInstallation Regency Direct Vent System Flex Option +H1+H2 Horizontal Venting with Two 2 90o ElbowsOption + H1 Option +H1Option +V1 +H1 Horizontal Venting with Three 3 90o ElbowsVertical Venting with Two 2 90o Elbows Option +V1Vertical Venting with Three 3 90o Elbows Description Vertical Termination With CO-LINEAR Flex SystemRequired Parts Alternate Approved CapsVenting Arrangements Vertical Terminations Horizontal Distance FeetUnit Installation with Horizontal Termination Snorkel TerminationsLock joint Unit Installation With Vertical Termination GAS Line InstallationThis allows for small adjustments High Elevation Pilot AdjustmentGAS Pipe Pressure Testing T. Valve DescriptionFor P33-4/H25-1 Using SIT 820 Nova Gas Valve Conversion KIT# 434-969 from NG to LPGlow on logs Installation of the DC Sparker for the P33-4 Unit Only 250 251Cutout Standard Flush DoorOptional Flush Trim 5th Grate TabOptional BAY Trim Flush LouversDouble Screen Door Optional BAY DoorBay Louver Top Heat Shield BAY LouversFlush Louver Top Heat Shield Burner ON/OFF Control boxFull Screen Doors Cut-Out Oblong Hole Top Flange BottomCut-Outs Hinge Location Bottom Grill Top GrillThermostat Wire Table Remote ControlWall Switch Wall ThermostatWiring Diagrams Do not cut the ground terminal off under any circumstancesFor Propane Units and Units Equipped with DC Spark Boxes Installing the Optional FAN Secure the 2 boxes together With one screwOperating Instructions Copy of the Lighting Plate InstructionsAeration Adjustment Lighting ProcedureShutdown Procedure Operating InstructionsLOG Replacement MaintenanceNormal Operating Sounds Maintenance GAS AppliancesThermopile Thermocouple Flush Glass ReplacementBay Glass Replacement Glass GasketRemoving Valve Installing ValveDiagram 3 Lift out Valve Tray Assembly Shut off the gas supplyParts List Main AssemblyDescription Parts List Burner & LOG Assembly Part DescriptionFlush Front & Louvers Regency Logo Plate Not available as a replacement part BAY Front & LouversRegency P33-4 Zero Clearance Direct Vent Gas Fireplace Warranty Warranty Limited LifetimeInstaller Please complete the following information

P33-NG4 specifications

The Regency P33-NG4 is a notable offering in the realm of modern communication technology, making waves with its innovative design and robust set of features. This advanced radio has been engineered to meet the demands of both professional users and casual enthusiasts. Its emphasis on reliability, durability, and user-friendly operations positions the P33-NG4 as a leading choice for users in various settings, from emergency services to outdoor adventures.

One of the standout features of the Regency P33-NG4 is its superior audio clarity. It is equipped with advanced noise-canceling technologies that ensure clear communication even in loud environments. Whether you are navigating through bustling city streets or communicating in a remote area, users can expect crisp and intelligible sound. Additionally, the P33-NG4 boasts an impressive range, allowing for seamless communication over long distances, which is essential for coordination during events or emergency situations.

The device supports both analog and digital modes, making it versatile for a range of applications. This feature enables the P33-NG4 to connect easily with other devices, enhancing interoperability in diverse communication scenarios. Its digital capabilities include advanced encryption for secure transmissions, making it a reliable tool for sensitive communications in professional environments.

Another highlight of the P33-NG4 is its rugged construction. Designed to withstand harsh conditions, it is dustproof, waterproof, and impact-resistant. This resilience is crucial for users in demanding fields, ensuring that the device will perform reliably in adverse weather conditions or challenging terrains.

Battery life is another critical characteristic of the P33-NG4. It comes equipped with a high-capacity battery that provides extended usage between charges. This ensures that users remain connected for longer periods, particularly in fieldwork situations where charging options may be limited.

Ease of use is a principle that underlies the design of the Regency P33-NG4. The interface is intuitive, featuring clear displays and tactile buttons for intuitive navigation. Users can quickly access critical functions without extensive training, making it suitable for both seasoned professionals and newcomers to radio communications.

In summary, the Regency P33-NG4 blends innovative technology with practical features, making it a standout choice for a wide array of users. With its clear audio, robust build, versatile communication modes, and user-friendly design, it demonstrates a commitment to quality and performance that is crucial in today’s fast-paced communication environment. Whether for safety, connectivity, or team coordination, the P33-NG4 rises to the occasion.
Top Page Image Contents