Electrolux LU4 9QQ user manual Ventilation mode, To change air flow direction

Page 18

Ventilation mode

In this mode, the air conditioner ventilates the air to outdoors

Install the exhaust hose (See Page 7-8), turn the drainage nozzle to the CLOSE position, and check the drainage nozzle is covered with the stopcock (upper).

1. Press the MODE button to select VENT mode.

COOL DEHUM FAN VENT

2.Press the ON/OFF button to start operation.

The red OPERATION lamp on the unit will illuminate.

The temperature cannot be set.

3.Press the FAN button to set the desired fan speed.

Although the louvres are closed and no air blows out into the room, the external ventilation fan speed changes.

QUIET LOW HIGH

2

1

3

To turn off

Press the ON/OFF button again.

• The red OPERATION lamp on the unit will turn off.

electrolux EXP09CS1WI ventilation mode/air flow direction 15

To change air flow direction

Up/down air flow direction

1.Press the ON/OFF button to start operation.

The red OPERATION lamp on the unit will illuminate.

2.Press the SWING button on the remote control.

The horizontal louvres will swing continuously.

3.Press the SWING button again when the horizontal louvres are at the desired position.

The horizontal louvres will stop moving.

The adjusted position will be memorized and the same position will be set automatically when operated the next time.

NOTE

During VENTILATION mode, UP/DOWN air flow direction cannot be changed.

���������� �������

Left/right air flow direction

Hold the vertical louvre as shown in the diagram below and adjust the air flow direction.

�������� �������

Never attempt to adjust the horizontal louvres manually.

Manual adjustment of the horizontal louvres can cause the unit to malfunction when the remote control is used for adjustment.

When the horizontal louvres are positioned at the

lowest position in the COOL or DEHUMIDIFICATION mode for an extended period of time, condensation may result.

Do not adjust the vertical louvres to the extreme left or right in the COOL mode with the fan speed set to “QUIET ( )” for an extended period of time.

Condensation may form on the louvres.

Image 18
Contents Portable air conditioners Remote control display Rear viewContents CongratulationsInformation on disposal for users Electrolux EXP09CS1WI front/rear view  Welcome to the world of ElectroluxImportant safety instructions Important notesIt may cause an injury Points to keep in mind when using your air conditioner Usage cautionsOperating conditions IncludedIncluded only together with window kit Using the remote control Loading the batteries use two AAA 1.5V alkaline batteriesAttach the Exhaust adapter to the exhaust hose Installation and removal of exhaust hoseUnacceptable Projection Hole Attach the exhaust hose adapter to the unitExhaust hose couple Projection Hole Installation of the exhaust hoseWindow exhaust adapter Extend Exhaust hose Unacceptable Acceptable Removal of the exhaust hoseProjection Window panel Installation of window kitHole Insect guard net Projection Foam seal a adhesive typeFoam seal a adhesive type Foam seal B adhesive type Adjustment panel 609mm 934mmExtension panel 934mm 1219mm Foam sealInstallation in a sliding sash window Window Cut Panel Adjustment panel Window panel 559mm 609mmInsect guard net Hole Foam seal B adhesive type Foam seal a adhesive type Extension panel934mm 1219mm Foam seal Cool mode Dehumidification modeFan mode To turn offVentilation mode To change air flow directionOff 1 hr timer To cancelTurbo cool operation Timer operation Timer offElectrolux EXP09CS1WI timer operation Timer on Plasmacluster operation Manual operationDrainage Stopcock Receptacle not supplied Drainpipe nozzleMaintenance Maintenance electrolux EXP09CS1WIVacuum Insect guard net Before calling for service Air conditioner does not cool properlyGuarantee/Customer Service European GuaranteeWarranty 22 electrolux EXP09CS1WI Electrolux EXP09CS1WI front/rear view