usingoperatheingremoteconditions/energycontrol electroluxtips/inclusionsEXP09CS1WIelectrolux EXP09CS1WI
Using the remote control | How to use the remote control |
Loading the batteries (use two AAA 1.5V) alkaline batteries
1.Remove the battery cover at the back of the remote control.
2.Insert batteries into the compartment, making sure
the 
and 
polarities are correctly aligned, as shown.
•Lines will appear on the display when batteries are properly installed.
3.Reattach the battery cover.
4.Press the RESET button using a thin pointed implement.
BatteryBattery covercover
LinesLines
Pointedinted implementi ple ent
NOTES:
•Batteries should last approximately one year under normal use.
•When replacing the batteries, always change both batteries at the same time, and make sure they are the same type.
•If the remote control does not operate normally after replacing the batteries, press the RESET button using a thin pointed implement.
•If you will not be using the unit for a prolonged period, remove the batteries from the remote control.
•Do not use rechargeable batteries.
Point the remote control towards the units signal receiver window and press the desired button. A beep will sound when the unit receives the signal.
•Make sure nothing, such as curtains, block the signal receiver window.
•The remote control operates up to 7 meters away.
•Do not expose the signal receiver window to direct sunlight. This may adversely affect its operation. If necessary, close curtains to block out the sunlight.
•Use of a fluorescent lamp in the same room may interfere with transmission of the signal.
•The unit may be affected by signals emitted from other remote controllers for televisions, VCRs or other equipment used in the same room.
•Do not leave the remote control exposed to direct sunlight or near a heater. Protect the remote control from moisture and shock which can discolour or damage it.
To prevent the remote control from being misplaced, hook it to the unit when not in use.
When attached, to remove the remote control from the unit, lift the remote control up slightly and pull it out from the remote control hook.
Remote������ control�������hook����