Operating conditions, Included | Electrolux LU4 9QQ specs

Operating conditions

•The air conditioner must be operated within the temperature range indicated in the table below.

•Available for operation at condition of supply voltage 220V to 240V at 50Hz.

•A built-in safety device may cut off operation if the temperature exceeds these limits.

•When cooling operation is performed at high room temperature, the fan may run slightly slower.

Mode	Room temperature
Cool	upper limit	35°C
	lower limit	18°C
Dehumidification	lower limit	15°C

electrolux EXP09CS1WIelectrolux EXP09CS1WIoperating conditions/includedfr t/rear vi w

Included

Exhaust hose (1) Window exhaust adapter (1)

Remote control (1)

Insect guard net (1)

Energy efficiency tips

•	Avoid direct sunlight
	Close blinds, drapes or shades to keep out direct
	sunlight while in cooling mode.
•	Keep the filter clean

Battery (2) (AAA.1.5V)

Hose clamp (1)

Keeping the filter clean greatly aids efficient operation.

A dirty filter blocks the flow of air, making your air

conditioner work harder and less efficiently.

See page 15 on how to clean the filter.

• Turn off unnecessary lights

Your air conditioner must remove the heat produced by

your lights or other heat-producing appliances. Turn off

any lights or appliances that are not in use.

• Turn off the air conditioner when no one is home

Use only when necessary. The less time the air

conditioner is used, the lower the running costs.

Location

•The air conditioner should be placed on a firm foundation to minimize noise and vibration. For safe and secure positioning, place the unit on a smooth, level floor strong enough to support the unit.

•The unit has casters to aid placement, but it should only be rolled on smooth, flat surfaces. Use caution when rolling on carpet surfaces. Do not attempt to roll the unit over objects.

•The unit must be placed within reach of a properly rated earthed socket.

•Never place any obstacles around the air inlet or outlet of the unit.

•Allow at least 30 cm of space on either side from the wall for efficient air-conditioning.

��

Suction disk (1)	Manual (1)

Included only together with “window kit”

Extension panel (1)

Foam seal (1) Foam seal (3)	Foam seal (1)
(adhesive type) A	(adhesive type) B

Bracket (1)	Rain guard (2)
Rain guard (2)	Hose clamp (1)
	Screw (8)

Exhaust cover (1)

(1)

Adjustment panel (1)

Window panel (1)

Suggested tools for window kit installation

1.Screwdriver (medium size Phillips)

2.Tape measure or ruler

3.Knife or scissors

4.Saw (in the event that the window panel needs to be cut down in size because the window is too narrow for direct installation)