Operating Instructions
USING THE REMOTE CONTROLLER BUTTONS
|
|
| TIMER OPERATION |
|
|
| To set the |
ON/OFF |
| MODE | 1) Push the TIMER button when the unit is |
|
|
| operational, only the |
| S |
| can be set. |
UP | DOWN | 2) Keep pressing the TIMER button, each | |
TEMP |
| TEMP |
|
| SAVER | 1 | press will increase the selected time by |
| ENERGY |
|
|
FAN |
| TIMER | 1 hour increments, up to 12 hours. |
3)The time can be set in a range of 0~12
|
| hours. |
AIR | SLEEP | 4) After the desired time has established, |
CLEAN |
| |
|
| wait for about 10 seconds until the |
|
| setting temperature reverts back in the |
|
| display window of the air conditioner. |
|
| This indicates the program is set. |
NOTE:
To cancel the TIMER setting, push the TIMER button until 0 hour is displayed on the LCD window of the air conditioner.
ON/OFF |
| MODE |
TEMP | S | TEMP |
UP | DOWN | |
| ENERGY |
|
| SAVER |
|
FAN |
| TIMER |
CLEAN AIR OPERATION
When this button is pushed, the ion gener- ator is energized and will help remove pollen and impurities from the air. Press it again to stop the operation.
1
CLEAN | SLEEP |
AIR |
|
ON/OFF |
| MODE |
TEMP | S | TEMP |
UP | DOWN | |
| ENERGY |
|
| SAVER |
|
FAN |
| TIMER |
ENERGY SAVER OPERATION
1
In this mode, the fan will continue to run for 3 minutes after the compressor shuts off. The fan then cycles on for 2 minutes at 10 minute intervals until the room temperature is above the set temperature, at which time the compressor turns back on and cooling stars.
CLEAN | SLEEP |
AIR |
|
13