Danby DAC8011E Operating Instructions, KEY PAD Features, While the Air Conditioner is off Auto-On

Operating Instructions

KEY PAD FEATURES

	LED
	Display
Temp / Timer
Control	68
	Auto
	Timer
Check	Sleep
	Mode
Filter
Auto	Auto
	MODE
Mode	Fan
	Speed
Selector
Energy	Power
	Button
Saver

LED DISPLAY: Displays the following information independently;Set Temperature, Ambient RoomTemperature and Auto Timer On/Off settings.

POWER: Turns unit On/Off.

MODE: Allows you to scroll through and select the desired operating mode; Cool , Dry , Fan Only and *Auto .The selected mode will be denot- ed by the adjacent indicator light.*‘Auto’is a pre-set factory program that automatically defines the mode (Cool or Dry) and fan speed based on the set temperature.

FAN SPEED: Select from four different fan settings;Low , Medium , High and Auto during Cool and Fan Only mode. Please note: During ‘Dry’ mode the fan speed is automatically defined .

ENERGY SAVER: Automatically cycles the fan on and off while the compressor is not in use.

TEMP / TIMER CONTROL: Used to increase or decrease

the Temperature setting in 1°C / °F increments, and Auto-Timer On/Off set- tings in 30min./1hr. increments. Note: This appliance allows you select the temperature scale to be displayed in either “Celsius” or Fahrenheit” according to your preference.To change the temperature scale displayed on the electronic display, press both the “Temp/Timer”adjust arrows simul- taneously to alternate between “Celsius” & “Fahrenheit”.

CHECK FILTER: The adjacent indicator light will illuminate as a reminder to clean the air conditioner filter (see page 9) Once the filter has been cleaned and replaced, depress the Check Filter button in order to resume operation.

SLEEP MODE: When activated, the current set temperature is gradu- ally increased over a one (1) hour period then maintained for seven (7) hours. Once the program is complete, the air conditioner will resume to its previous set temperature (before sleep mode was activated). This feature is mean to be used during the night time hours to prevent the room from getting too cold (while you sleep) and results in less compressor running time and reduced energy consumption. Sleep mode may be cancelled by depressing the Sleep Mode button while the program is running.

AUTO-TIMER:Used to initiate the Auto On/ Auto Off timer.

While the Air Conditioner is off (Auto-On):

1)Press the Auto-Timer button once and the adjacent Auto-On indicator light will illuminate.

2)Use the Temp/Timer control cursors to select a delayed On time of up to 24 hours.

3)Select the appropriate mode under which you want the unit to operate (Auto-Cool-Dry-Fan Only)

4)Select the fan speed setting.

5)The time you selected will appear in the LED display.

While the Air Conditioner is on (Auto-Off):

1)Press the Auto-Timer button twice and the adjacent Auto-Off indicator light will illuminate.

2)Use the Temp/Timer control cursors to select a delayed Off time of up to 24 hours.

3)The time you selected will appear in the LED display. The Auto On and Auto Off timer can operate during the same program by defining the Auto-Off parameters immediately after the Auto On parameters.The Auto-Timer may be cancelled at any time by turning the unit On/Off.

8