Integra DTR-5.5 instruction manual Precautions, FCC Information for User, Power

Page 3

DTR-6.5,5.5_En.book Page 3 Wednesday, July 28, 2004 9:07 AM

Precautions

For U.S. Models

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to Section 820-40 of the NEC which provides guidelines for proper grounding and, in partic- ular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

FCC Information for User

CAUTION:

The user changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protec- tion against harmful interference in a residential instal- lation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a partic- ular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encour- aged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

1.Recording Copyright—Unless it’s for personal use only, recording copyrighted material is illegal with- out permission of the copyright holder.

2.AC Fuse— The AC fuse inside the AV receiver is not user-serviceable. If you cannot turn on the AV receiver, have it checked by the dealer from whom you purchased this unit.

3.Care—Occasionally you should dust the AV receiver all over with a soft cloth. For stubborn stains, use a soft cloth dampened with a weak solu- tion of mild detergent and water. Dry the AV receiver immediately afterwards with a clean cloth. Don’t use abrasive cloths, thinners, alcohol, or other chemical solvents, because they may damage the finish or remove the panel lettering.

4.Power

WARNING

BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME, READ THE FOLLOWING SECTION CAREFULLY.

AC outlet voltages vary from country to country. Make sure that the voltage in your area meets the voltage requirements printed on the AV receiver’s rear panel (e.g., AC 230 V, 50 Hz or AC 120 V, 60 Hz).

Setting the [Standby/On] switch to Standby does not fully shutdown the AV receiver. If you do not intend to use the AV receiver for an extended period, remove the power cord from the wall outlet.

For Canadian model

NOTE: THIS CLASS B DIGITAL APPARATUS COMPLIES WITH CANADIAN ICES-003.

For models having a power cord with a polarized plug:

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

Modèle pour les Canadien

REMARQUE: CET APPAREIL NUMÉRIQUE DE LA CLASSE B EST CONFORME À LA NORME NMB-003 DU CANADA.

Sur les modèles dont la fiche est polarisée:

ATTENTION: POUR ÉVITER LES CHOCS ÉLEC- TRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRE- SPONDANTE DE LA PRISE ET POUSSER JUSQU’AU FOND.

Thank you for purchasing an Integra AV Receiver.

Please read this manual thoroughly before making any connections and plugging it in. Following the instructions in this manual will enable you to obtain optimum perfor- mance and listening enjoyment from your new AV Receiver.

Please retain this manual for future refer- ence.

3

Image 3
Contents DTR-6.5/5.5 Avis Important Safety InstructionsFCC Information for User PrecautionsPower For models having a power cord with a polarized plugIf in any doubt, consult a qualified electrician Supplied AccessoriesPrecautions Make sure you have the following accessoriesDTR-5.5 FeaturesDTR-6.5/5.5 DTR-6.5Table of Contents Table of Contents DTR-5.5 Front & Rear PanelsFront Panel DTR-6.5Front & Rear Panels Rear Panel DisplayIR IN/OUT Component Video in 1, 2, 3 28, 30RS232 12V Trigger OUT A/B/C 73Phono in DTR-6.5 only Optical Digital 27, 28, 30, 32, 34Coaxial Digital 27, 28, 30, 32, 34 Grounding screw DTR-6.5 onlyRemote Controller Installing the BatteriesUsing the Remote Controller RC-585M Remote ControllerReceiver Mode Remote indicatorOn button Remote Mode buttonsListening mode buttons 58 Surrond button Standby buttonDVD Mode CD Mode Pause button MD/CDR ModePlay button Previous & Next / buttonsReverse Play button Tape ModeFR & FF Buttons Stop buttonEnjoying Home Theater About Home TheaterAV Connection Color Coding Connecting the AV receiverAbout AV Connections Optical Digital JacksConnecting Your Speakers Connecting the AV receiverSpeaker Connection Precautions Connecting the Speaker CablesStrip about 5/8 15 mm Attach the FM antenna, as shown American Model Connecting AntennaConnecting the Indoor FM Antenna Connecting the AM Loop AntennaConnecting an Outdoor FM Antenna Connecting an Outdoor AM AntennaUsing a TV/FM Antenna Splitter Audio Connection Formats Connecting Both Audio & VideoWhich Connections Should I Use? Video Connection FormatsConnecting Your TV or Projector Monitor OutAudio Connections DVD player Connecting a DVD PlayerVideo Connections Your TV must also be connected via component videoUsing a Multichannel Connection Connecting a D-VHS VCR for Playback Connecting a VCR for PlaybackTV or VCR, etc Connecting a VCR for RecordingPlayback from the Recording VCR VCR recordingUsing Optical or Coaxial Connections PRSatellite, cable, set-top box, LD player, etcSatellite, cable, set-top box, LD player, etc Connecting a Camcorder, Games Console, etc Using Analog Connections Using S-VideoCamcorder Games console, etc CD player Connecting a CD Player Connecting a Cassette RecorderConnecting a DAT, CD, or MD Recorder Analog ConnectionsUsing Optical or Coaxial Connections playback only Digital RecordingDigital source DAT, CD, MD player Connecting a Turntable For the DTR-6.5For the DTR-5.5 Is for connecting more -compatible components Connecting a Power Amplifier DTR-6.5 onlyConnecting Components When you start playback on an AV component conTurning On the AV receiver Connecting the Power Cords of Other ComponentsConnecting the Supplied Power Cord Connecting the RS232 PortAutomatic Speaker Setup First Time SetupFirst Time Setup About the Onscreen Setup Menus Main menusSubmenus Digital Input Initial SetupTor, and then use the Left Component Video SetupMain menu appears onscreen Buttons to select an input selecAnce Minimum, and then use Press the Receiver button fol- lowed by the Setup buttonMinimum Speaker Impedance not American models Buttons to select b. Sp ImpedThen use the Left and Right TV Format Setup not American modelsHere you can specify the TV format used in your area Buttons to select c. TV FormatButtons to select a. Subwoofer Speaker SetupSpeaker Setup menu appears Buttons to select 2. SpeakerCrossover Tance, and then press Enter DefaultDouble Bass Speaker DistanceSpeaker Distance menu appears Buttons to specify the dis- tanceRepeat for all speakers Subwoofer 0dB Speaker Level CalibrationEqualizer Setting Repeat this step to select TAPE, MD, or CDR Changing the TAPE/MD/CDR DisplayStart playback on the source component Only the RC-585M remote controller has a Phono buttonBasic Operation Selecting the Input SourceBasic Operation Setting the Display BrightnessUsing the Sleep Timer Using HeadphonesInterpreting Surround Channel Values Displaying Source InformationYou can display various information about the current Input source as followsUse the Tuner input selector Using the TunerTuning into Radio Stations Listening to the RadioDisplaying Radio Information Presetting Radio StationsSelecting Preset Stations Deleting PresetsTHX button DTR-6.5 only Selecting with the Remote ControllerSelecting on the AV receiver Surrond buttonMultich About the Listening Modes Onkyo Original DSP Modes Advanced Operation Using the Re-EQ FunctionUsing the Late Night Function Dolby Digital only Using the CinemaFILTER DTR-5.5 onlyAdvanced Operation Adjusting Individual Speaker LevelsRecording Audio RecordingRecording Separate AV Sources AV RecordingDolby Digital Advanced SetupDecoder Setup Analog/PCMMultiplex Advanced SetupDTS D.F chAudio Adjust Functions Audio Adjust menu appearsSettings are explained below PLIIx/Neo6 MonoAssigning Listening Modes to Input Sources Theater-DimensionalPreference menu appears Setting PreferencesUse the Up and Down Buttons to select the signal for This section explains the items on the Preference menuRemote Setup IntelliVolumeVolume Setup OSD SetupChanging the Remote Controller’s ID 6-7., 6-8 V Trigger SetupDigital Format Using Only Speakers in Zone Using a Receiver/Integrated Amp in ZoneZone Buttons to select 3. Hardware Buttons to select a. PoweredHardware Setup menu appears Zone 2, and use the LeftZone 2 OUT L/R jacks can also be used as pre Outs Hardware Setup menu appearsUsing Zone Using a Multiroom Kit with Zone Using the Remote Control in ZoneUsing the 12V Trigger Adjusting the Bass & Treble for Zone2Controlling Out-of-range Components Using a Multiroom Kit with a CabinetCodes for Integra DVD Players Entering Remote Control CodesSetting the MD/CDR Button to CDR Controlling Other ComponentsResetting Remote Mode Buttons Resetting the Remote ControllerControlling Other Components Remote Control Codes DVD DVD playerSAT satellite receiver ABC CBL cable receiverDTR-6.5,5.5En.book Page 84 Wednesday, July 28, 2004 907 AM DTR-6.5,5.5En.book Page 85 Wednesday, July 28, 2004 907 AM Controlling a Cable Receiver Controlling a TVButtons Controlling a VCR Controlling a Satellite ReceiverRec NumberLearning Commands from Another Remote Controller Using Macros Making MacrosRunning Macros Troubleshooting Troubleshooting Zone 2 has turned off? Remote controller doesn’t work?Can’t control other components? Can’t record?Display doesn’t work? Sound changes when I connect my head- phones?Speaker volume cannot be set as required? Speaker distance cannot be set as required?Video Section Specifications DTR-6.5Amplifier Section GeneralSpecifications DTR-5.5 3 4 3 8 2

DTR-5.5 specifications

The Integra DTR-5.5 is a prominent model in the world of home theater receivers, combining cutting-edge technology and user-friendly features to deliver an exceptional audio-visual experience. Known for its power and versatility, the DTR-5.5 successfully caters to both casual listeners and home cinema enthusiasts.

At the heart of the Integra DTR-5.5 is its high-performance amplification system, delivering 85 watts per channel across seven channels. This robust power output allows the receiver to easily drive demanding speaker setups and fill large rooms with rich, vibrant sound. The incorporation of advanced technologies like Dolby Atmos and DTS:X enhances the audio experience by providing immersive surround sound. These formats allow for object-based audio, creating a three-dimensional sound environment that makes movie watching or music listening feel truly captivating.

One of the standout characteristics of the DTR-5.5 is its extensive connectivity options. The receiver features multiple HDMI inputs, including 4K and HDR support, ensuring compatibility with the latest video sources and display technologies. It also includes digital and analog audio inputs, as well as Zone 2 outputs, making it suitable for multi-room audio setups. The built-in Wi-Fi and Bluetooth capabilities enable easy streaming from various devices, catering to modern consumer needs.

The user interface is designed with convenience in mind. The receiver comes equipped with an intuitive on-screen display, allowing users to effortlessly navigate settings and configurations. The Audyssey MultEQ room calibration technology optimizes speaker placement and acoustic performance, ensuring that users achieve optimal sound quality tailored to their specific room conditions.

In terms of aesthetics, the Integra DTR-5.5 is sleek and modern, fitting seamlessly into any home theater setup. Its solid construction not only enhances durability but also helps reduce resonance and interference, resulting in purer sound quality.

Overall, the Integra DTR-5.5 represents a perfect blend of power, connectivity, and advanced technology, making it an excellent choice for anyone looking to elevate their home audio experience. With its comprehensive feature set, it stands out in the competitive landscape of home theater receivers, ensuring that every listening session is truly enjoyable.