Integra DTR-5.5 instruction manual Recording Audio

DTR-6.5,5.5_En.book Page 64 Wednesday, July 28, 2004 9:07 AM

Advanced Operation—Continued

Recording

This section explains how to record the current input source, how to record one input source while enjoying another, and how to dub audio onto your video record- ings.

Unless you have the full consent of the copyright holder, copyright laws prohibit using your recordings for anything other than personal enjoyment!

Notes:

•The surround sound and DSP listening modes cannot be recorded.

•Copy-protected DVDs cannot be recorded.

•You cannot record from the DVD analog multichannel input.

•Various restrictions apply to digital recording. Refer to the manuals supplied with your digital recording equipment for more details.

•Digital input signals are output by only the digital out- puts, and analog input signals are output by only the analog outputs. There is no internal conversion from digital to analog or vice versa.

•DTS signals will be recorded as noise, so don’t attempt analog recording of DTS CDs or LDs.

2	Press the [Rec Out] button, and
	then use the Controller [ ]/[ ]
	buttons to select “Rec Sel :
	Source.”
	The current input source can be
	recorded by the recorder connected to
	the TAPE OUT.
3	Start recording on the recorder.
	See your recorder’s manual for more
	information.
4	Start playback on the source
	component.
	If you select another input source dur-
	ing recording, that input source will be
	recorded.

Recording Audio & Watching a Separate AV Source at the Same Time

While recording audio, you can watch a completely sep- arate AV Source at the same time. For example, you could watch a DVD while recording a CD to tape.

Rec Out

Zone 2

Standby

Input Selector

Controller

Recording Audio

You can record the current audio source as follows.

1	Use the input selector buttons to
	select the audio component that

you want to record.

1	Press the [Rec Out] button.
2	Within five seconds, use the
	Controller [ ]/[ ] buttons to
	select the audio input source that
	you want to record (you cannot
	select TAPE).
	The name of the input source selected
	for recording appears on the display.
	The specified input source can now be
	recorded by the recorder connected to
	the TAPE OUT.
3	Start recording on the recorder.
	See your recorder’s manual for more
	information.
4	Start playback on the audio
	source component.

Notes:

•Since the Zone 2 function and the REC OUT outputs use the same circuitry, you cannot record from a sepa- rate source and use Zone 2 at the same time.

•To turn off the REC OUT output (i.e., the TAPE OUT), press the [Rec Out] button, and then use the

Controller [] [ ] buttons to select “OFF.”

64