Integra DTR-5.5 instruction manual Initial Setup, Digital Input

DTR-6.5,5.5_En.book Page 42 Wednesday, July 28, 2004 9:07 AM

First Time Setup—Continued

Initial Setup

Digital Input

If you connect a component to a digital input jack, you must assign that jack to an input selector. For example, if you connect your CD player to the OPTICAL IN2 jack, you should assign that jack to the CD input selector. By default, the OPTICAL IN1 jack is assigned to the DVD input selector, although this can be changed.

	CD	Tape	Tuner
	7	8	9
	Phono			TV VOL
	+10	0	Clear
	--/---	Input Selector
		Macro
	1	2	3	Zone 2
1		Remote Mode
	Receiver	DVD	CD	MD/CDR
	Tape
	TV	VCR	Cable	SAT

3

Enter

Enter

Use the Up and Down []/[ ] buttons to select “1. Digital Input,” and then press [Enter].

The Digital Input menu appears.

Menu

------------------------
Basic Setup
1.Initial Setup	-
1-----------------------.Initial Setup

1.Digital Input
	1-1.Digital Input
------------------------2.Component Video
	a.DVD	:OPT1
	3.Surround Setup	:-----
	b.VIDEO1
4.Audio Adjust		:-----
	c.VIDEO2
5.Listening Mode Preset
	d.VIDEO3	:-----
6.Preference
	e.TAPE	:-----
	f.CD	:-----
	g.PHONO	:-----

	Dimmer						Sleep
2, 3	TV		enu		M	en
			pM
	Input	o				u
		T
	+							2–4
	CH			Enter			VOL
	Disc
	-		E			e		1, 5
				xit
					id
	Prev				Gu
		R	eturn			p
	CH				Setu
	Display						Muting
	Rec						Random
	Audio	Subtitle			Angle		Last Memory
	Surround		All ST		THX		Stereo
	Repeat		A-B		Search		Memory
	Pure A		Direct		DSP		DSP
	Test Tone	CH SEL			Level-		Level+
	Open/Close Video Off
1	Press the [Receiver] button fol-
	lowed by the [Setup] button.
Receiver

The main menu appears onscreen.

2	Use the Up and Down [ ]/[ ]
	buttons to select “1. Initial
Enter	Setup,” and then press [Enter].
	The Initial Setup menu appears.

Enter

42

•There are no assignments for

TUNER.

•VIDEO 4 is assigned to the optical digital input on the front panel and cannot be changed.

4 Use the Up and Down []/[ ] buttons to select an input selec- tor, and then use the Left and

Enter

Right []/[ ] buttons to select a digital input jack.

Examples:

If you connect your DVD player to the OPTICAL IN 2 jack, set “a. DVD” to “OPT2.”

If you want to listen to audio from the component connected to the OPTICAL IN 3 jack when the VIDEO 1 input selector is selected, set “b. VIDEO1” to “OPT3.”

If you want to listen to audio from the component connected to the COAX- IAL IN 1 jack when the VIDEO 2 input selector is selected, set “c. VIDEO2” to “COAX1.”

For input selectors that you don’t want to assign a digital input jack, leave them set to “-----.”

5	Press the [Setup] button.
	The setup menu closes.

Note:

•This procedure can also be performed on the AV receiver by using its [Setup] button, arrow buttons, and [Enter] button.