Riccar RSL1, RSL2C owner manual HOW to Change the Belt

Page 11

HOW TO CHANGE THE BELT

CAUTION: First, disconnect the vacuum

cleaner from the electrical outlet.

1.Turn the unit over and remove the bottom plate (see "How to Remove Bottom Plate").

2.Remove the brush roll and the worn or broken belt from the brush roll pulley and the motor drive shaft (diagram 13).

3.Loop the new belt around the motor drive shaft and the brush roll (diagram 14).

4.Reinstall the brush roll back into the housing. Turn the brush roll by hand, making sure the belt is not twisted and all rotating parts move smoothly (diagram 15).

5.Reinstall the bottom plate (see "How to Install Bottom Plate").

NOTE: To ensure maximum cleaning efficiency, the belt should be checked regularly to be sure it is in good con- dition. Check to see if the belt is stretched, cracked, or if excessive slipping has occurred. Replace if needed.

13

14

New belt

15

9

Image 11
Contents RSL2 RSL2C KEY Replacement Parts How To Table of ContentsImportant Safety Instructions Grounding Instructions Commercial Models Polarization Instructions Household ModelsAssembling the Vacuum Vacuum Assembly ProcedureAssembling the Vacuum Automatic Carpet Height Adjustment On / OFF SwitchEdge Cleaner HOW to Change the Vacuum BAG HOW to Remove / Install the Bottom Plate HOW to Change the Belt HOW to Replace the Headlight Bulb HOW to Reset the Circuit Breaker For Best Performance Riccar’s Limited Warranty Riccar Vacuum Cleaner Limited WarrantyItem IBRSL1B B503-1200C