Roper B675, 288, B460 Removable Oven Racks and Guides, Removable Oven and Broiler Doors, To remove

REMOVABLE OVEN RACKS AND GUIDES

Be careful not to scratch the oven finish when installing or removlng oven racks.

To Install:

1.Put the pegs on the end of the rack guide into the holes in the oven back.

2.Lock the front hook in the slot in the oven side.

3.Set the raised back edge of the oven racks on a pair of rack guides so the hooks at the sides of the rack run underneath the rack guides.

4.Push the rack in until you reach the bump in the rack, then lift the front of the rack a bit and push the rack all the way in.

To remove:

1.Pull the oven rack out, then up.

2.Lift thefrontoftherackguidetounhookitfromtheoven wall and pull out.

REMOVABLE OVEN AND BROILER DOORS

Remove the doors for easier cleaning.

To remove:

1.Open the door fully and raise the release tab on each door hinge (see fig. A).

2.Raise the release tabs as far as they will go (see fig. B), then close the door to the point where it will hold a partially open position.

3.Grasp the door firmly at the sides, pull the lower edge away from the oven and lift the door off the hinge arms (see fig. C).

To replace:

1.Slip the hinge arms into the upper portion of the slots in the door.

2.Lower the door to the fully open position and push the release tabs down (see fig. A).

REMOVABLE OVEN BOTTOM

Remove the oven bottom for easier cleaning.

Be careful not to scratch the oven finish when removing or installing oven bottom.

To remove:

1.Remove the oven racks and guides (see above).

2.Lift the front of the oven bottom enough to clear the front frame, then pull out.

To replace:

1.Slide the oven bottom into the oven so that the back edge of the oven bottom rests on the ridge in the back oven wall.

2.Lower the front of the oven bottom inlo place behind the front frame.

/	I
RACK HOOK	RACK
	BUMP
II II	II

’	Fig. A ”		‘/	Fig. B II
	\‘\‘.._	II		~~

FRONT FRAME

17 GMNT18