WhisperKool SS4000, SS7000 owner manual Condensing Unit Skid Preparation

Page 10

CONDENSING UNIT SKID PREPARATION

Note: The condensing unit is shipped with a protective foam pad/ block to prevent damaging tubing

against the condenser coil fins. Please ensure that this pad is removed prior to operation.

Condensing Unit

-10-

Image 10

Contents WhisperKOOL Page Table of Contents Temperature Differential Features & BenefitsCondensing Unit Installation, Indoors or Outdoors Humidity ControlThermostat Additional FeaturesEvaporator PDT Operating Instructions PDTPackage Contents Preparing the Wine Cellar Technical Specifications Wine Cellar / Space PreparationInstalling Condensing Unit Split System Installation GuidelinesGeneral Installation Guidelines and Instructions Mounting Evaporator UnitCondensing Unit Skid Preparation Condensing UnitHead Pressure Control, Low Ambient Control Switch Mounting the Evaporator Unit Remove interior assemblyDisassemble evaporator unit Mounting housing to wall Identify and remove appropriate knockoutsInstalling refrigeration lines into evaporator housing Re-install interior assembly Attaching refrigeration lines Install drain line fitting and drain line FanF1 J1 T3 J1 S1 S2 Thermostat Solenoid ValveInstall thermostat Install front cover Energize unitSplit System Wiring Schematic Wiring SystemRefrigeration Lines Split Unit Wiring Diagram Maintenance How To Contact Vinothèque Customer Service Technical AssistanceWine cellar temperature above thermostat set point TroubleshootingFault Cause Solution Water leaking from unitCompressor runs intermittently And/or cause for hot air recirculationCheck refrigerant sight glass in 1/4 tubing Evaporator blower runs, but compressor does notCompressor runs, but evaporator does not Evaporator coil freezesHumidity in cellar too high Installation Terms and Conditions Acceptance of Terms & Conditions Product InstallationMaintenance Customer Service Arbitration Questions or Additional Information Page Page