WhisperKool SS7000 Troubleshooting, Fault Cause Solution, Water leaking from unit, Fan Coil

Page 23

TROUBLESHOOTING

Fault Cause

Solution

Water leaking from unit

	1. Condensate drain	Clear out drain
	clogged

	2. Evaporator coil	Clean the coil and / or fan wheel
	frozen

	3. Drain line improperly	Call a CERTIFIED HVAC service technician.
	installed

Wine cellar temperature above thermostat set point

gj

1. Large quantity of	Allow time for wine to cool
warm wine placed in
cellar
2. Wine Cellar Door left	Close Door. Allow time for wine to cool.
open for long period.
3. No power to	Fan Coil
either fan coil unit or	Is the thermostat display illuminated?
condensing unit	If not, check power supply switch, if equipped. Ensure it
	is in the ON position.
	If on, check to see in the breaker is tripped.
	If tripped, reset and check display.
	If display “Wine” bar is illuminated, wait for time delay to
	expire. Wine light blinks during time delay countdown.
	Check to see if “On” bar indicator illumination appears
	at which time the blower and cooling should start
	If blower starts and no cooling follows, check power
	supply to condensing unit.
	Check breaker to condensing unit. If tripped, check to
	see if compressor is hot – too hot to touch. If so, allow
	to cool for one (1) hour before resetting breaker.
	After cooling, reset breaker and note whether it remains
	set or trips off. If it trips, call a CERTIFIED HVAC service
	technician for repair.

-23-

Image 23

Contents WhisperKOOL Page Table of Contents Humidity Control Features & BenefitsCondensing Unit Installation, Indoors or Outdoors Temperature DifferentialEvaporator Additional FeaturesThermostat PDT PDT Operating InstructionsPackage Contents Wine Cellar / Space Preparation Preparing the Wine Cellar Technical SpecificationsMounting Evaporator Unit Split System Installation GuidelinesGeneral Installation Guidelines and Instructions Installing Condensing UnitCondensing Unit Condensing Unit Skid PreparationHead Pressure Control, Low Ambient Control Switch Disassemble evaporator unit Remove interior assemblyMounting the Evaporator Unit Identify and remove appropriate knockouts Mounting housing to wallInstalling refrigeration lines into evaporator housing Re-install interior assembly Attaching refrigeration lines FanF1 J1 T3 J1 S1 S2 Thermostat Solenoid Valve Install drain line fitting and drain lineInstall front cover Energize unit Install thermostatRefrigeration Lines Wiring SystemSplit System Wiring Schematic Split Unit Wiring Diagram Maintenance Technical Assistance How To Contact Vinothèque Customer ServiceWater leaking from unit TroubleshootingFault Cause Solution Wine cellar temperature above thermostat set pointAnd/or cause for hot air recirculation Compressor runs intermittentlyEvaporator blower runs, but compressor does not Check refrigerant sight glass in 1/4 tubingEvaporator coil freezes Compressor runs, but evaporator does notHumidity in cellar too high Acceptance of Terms & Conditions Product Installation Installation Terms and ConditionsMaintenance Customer Service Arbitration Questions or Additional Information Page Page