WhisperKool SS7000, SS4000 owner manual Thermostat, Evaporator, Additional Features

Page 5

System & Features

The system includes both the evaporator and condensing units packaged in two (2) separate containers. An exterior housing is required for outdoor installations and will arrive packed separately.

Evaporator

Condensing Unit (Shown With Housing)

Thermostat

The split system evaporator has been designed to incorporate the Vinothèque PDT ™ series thermostat.

Years of research and testing have gone into the design of the PDT thermostat resulting in advanced microprocessor controlled digital technology and pinpoint accuracy. This system incorporates a probe designed to measure the liquid temperature in a wine bottle rather than the air temperature of the cellar. This results in several distinct advantages:

Wine is maintained at a precise, measured temperature.

The unit will switch on/off less often, extending cooling unit life.

The unit will run longer during cycles effectively maintaining humidity.

Additional Features:

Digital probe - contains a microchip which communicates back and forth to the thermostat resulting in accuracy.

Heavy Duty Circuitry - designed to resist power surges, which play havoc on sensitive electrical components.

Fahrenheit and Celsius readout - for use in the United

PDT Thermostat

States as well as around the world.

 

-5-

Image 5
Contents WhisperKOOL Page Table of Contents Condensing Unit Installation, Indoors or Outdoors Features & BenefitsTemperature Differential Humidity ControlEvaporator Additional FeaturesThermostat PDT PDT Operating InstructionsPackage Contents Wine Cellar / Space Preparation Preparing the Wine Cellar Technical SpecificationsGeneral Installation Guidelines and Instructions Split System Installation GuidelinesInstalling Condensing Unit Mounting Evaporator UnitCondensing Unit Condensing Unit Skid PreparationHead Pressure Control, Low Ambient Control Switch Disassemble evaporator unit Remove interior assemblyMounting the Evaporator Unit Identify and remove appropriate knockouts Mounting housing to wallInstalling refrigeration lines into evaporator housing Re-install interior assembly Attaching refrigeration lines FanF1 J1 T3 J1 S1 S2 Thermostat Solenoid Valve Install drain line fitting and drain lineInstall front cover Energize unit Install thermostatRefrigeration Lines Wiring SystemSplit System Wiring Schematic Split Unit Wiring Diagram Maintenance Technical Assistance How To Contact Vinothèque Customer ServiceFault Cause Solution TroubleshootingWine cellar temperature above thermostat set point Water leaking from unitAnd/or cause for hot air recirculation Compressor runs intermittentlyEvaporator blower runs, but compressor does not Check refrigerant sight glass in 1/4 tubingEvaporator coil freezes Compressor runs, but evaporator does notHumidity in cellar too high Acceptance of Terms & Conditions Product Installation Installation Terms and ConditionsMaintenance Customer Service Arbitration Questions or Additional Information Page Page