Winix Air Cleaner manual Dust Sensor Cleaning 5000 and 5000S

Page 13

Mesh/ Activated Carbon Filter every three months with normal use. The interval between cleanings will vary based on room conditions.

NOTE: Do not wash and reuse True HEPA filter (5000 and 5000S), HEPA filter (5000B, and Carbon Pre-Filter (5000B)

1.Remove the front panel and filter cassette as described in Replacement Procedure.

2.Remove the Pre-Filter by gently pulling one side of the cassette frame outward while lifting the Pre-Filter tab at the same time. When one edge is clear of the frame, the Pre-Filter will slide out for cleaning.

3.Lightly vacuum the Pre-Filter and wash with water and a mild household deter- gent. Rinse, and shake off excess water.

4.To remove the Washable Nano-Silver Mesh/Carbon Filter, turn the cassette over and place face-down on an even surface. Slightly flex the cassette frame outward while pulling up on the long tab.

NOTE: Never attempt to remove the True HEPA Filter from the cassette frame. Never attempt to clean the True HEPA Filter. Replace the entire cassette only when REPLACE FILTER alert activates.

When the first corner is released, pull out on the other long frame tab while continuing to pull out on the filter tab. When one long edge of the filter is free, slide out for cleaning.

5.Wash the filter in warm water with a mild household detergent. Rinse, and shake off excess water.

6.Do not dry the two filters—running the unit will be sufficient to dry them.

7.Replace each filter in the cassette frame by inserting one long edge first, then snapping into place by pushing sideways and down at the same time. Make sure both filters are completely inside the cassette frame and secured by the short tabs. If a filter is on top of one or more tabs, pull outward, slightly flexing the cassette frame, while gently pushing down on the edge of the filter.

8.Replace the filter cassette and front panel as described in Replacement Procedure.

9.Plug in the power cord to a wall outlet and turn on the unit.

Dust Sensor Cleaning (5000 and 5000S)

Lightly vacuum the dust sensor every two months after removing the front panel.

NOTE: Dust Sensor is not equipped in 5000B.

 

FILTER CASSETTE

CASSETTE

FILTER TAB

SHORT TABS

 

CASSETTE

LONG TABS

12

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Page Page Warranty Table of ContentsPackage Contents Safety InstructionsImportant Instructions for Using Your AIR Cleaner Product SpecificationsMULTI-STAGE Cleaning AIR Cleaner FeaturesWashable Carbon Filter 5000 & 5000S AIR Cleaner SET-UPPlasmaWave All Display Panel 5000 and 5000S FAN Speed Indicator Shows current fan speed settingDisplay Panel 5000B Operation Sleep ModeAutomatic Operation Manual OperationUsing the Remote Control Remote ControlFAN Control Filter Cassette Replacement Care and MaintenanceReplacement Procedure Filter Cleaning 5000 and 5000SDust Sensor Cleaning 5000 and 5000S Solutions to Common Problems TroubleshootingProblem Possible Solution Page Garantía ÍndiceContenido DEL Paquete Instrucciones DE SeguridadNo manipular el enchufe con las manos mojadas Especificaciones DEL ProductoCaracterísticas DEL Purificador DE Aire Montaje DEL Purificador DE Aire Pantalla 5000 y 5000S Cambiar EL Medidor Pantalla 5000BEL Indicador DE Velocidad Modo Automático OOperación Automática OperaciónOperación Manual Detectores DE Polvo Y OloresAparato DE Control Remoto Botón Power Botón Turbo Botón AUTO/SLEEP Botón Timer Botones Limpieza Cuidado Y MantenimientoReemplazo del marco del filtro Procedimiento del recambioMarco DEL Filtro Limpieza del detector de polvo 5000 y 5000SSolución de problemas comunes Resolución DE ProblemasProblema Posible Solución Asegúrese de mencionar el número del modelo Servicio AL Cliente
Top Page Image Contents